Recent content by neo2uzfe

No rubbing. Edge surround foam seem ok. No tears. Solid and soft on touching. I tried pushing them in out. It goes without rubbing. I guess they became weak. Sound bad means, no cracking or popping sound, just low volume and no bass. Especially rear ones. Front even with a hole, sounds better. I...

Front: Rear: Both foam surrounds looked fine. No cracks or tears, even by touching there’s no disintegration. Noticed a hole on front one. Rear one is having no visible damage yet it sound worse. Rear doesn’t have integrated tweeter as I was expecting. They say it is a full range speaker...

Happened to open up door cards to check. Confirmed both front and rear door speakers are 5.25”. Along with the 3- hole bracket, it measures close to 6in. Woofer in the cargo area is probably 6”. To my surprise, both front and rear door speaker surrounds were in good condition. The foam isn’t...

No. Check the one the person is holding. He replaced it with aftermarket. The pic below that is an oem one for sale in ebay.

That’s my current plan. But it looks a bit different from the ML surrounds or any surrounds they list. Not even sure they are foam or butyl. Posting a picture I found on mud below. The person holds oem pioneer in his hand.

I would love to. But I don’t have Mark levinson. I have the Standard lexus system. I’m having a hard time to identify the refoam kits for it. 1000s of thread on Mark levinson, not a single one for pioneer 7 speaker system. Don’t know whether they disintegrate like ML surrounds. But my audio...

Just to be clear, do you have a Mark levinson system or pioneer system? If you have the later, the 4” foams you bought worked? Which is the kit you ordered?

This the diagram reference of my speaker setup:

Dear Mud, My 2005 LX470 has a Non-ML audio configuration. It has the standard Pioneer 7 speaker system. I recently noticed some of my speakers getting weak. No odd cracking sounds. But I guess after this much years in hot dry climate, the speaker foams might have disintegrated. I am having a...

Looking for all three oem ride height sensors for 100 series AHC. Good condition light used ones preferred. If you’re parting out or have a set sitting on your garage, kindly inform.

Is your car diesel? There can be difference in diesel rear coil spring. When you correct rear pressures, the front might come in spec.

Did you complete the delete?? Hope you replaced torsion bar. You better replace sway bar to non-ahc one as well. Otherwise, it will not ride like a cruiser. On highway it would look smooth. But lean on corners and harsh ride on rough roads would be significant. If it is harsh on highway, check...

Looking for OEM/ AISIN ride height sensors in good condition.please Send a message if you have it. 89405-60010, 8940660010,8940760010. AISIN HST-020,AISIN HST-021, AISIN HST-026 Thanks

Unless your truck has too much rust and you intend to use it for large amount of loaded up offroad, you are not going to enjoy a low to mid budget conventional swap. Body roll will be significant with oem toyota shocks paired with lx sway bars, rear will sag when you load up the cargo...

Thank you very much. Yes. O rings and plastic back up rings and washers( same as retainers?) has to be replaced with new. Do you have a list of bushings you replaced? A write up will be beneficial. Thanks again