Recent content by MTsoul

  1. MTsoul

    Build Little Green Monster - 1st Gen 4Runner

    Rear End: Gas Tank (and Start!) I had to replace the fuel pump hanger I damaged when removing the tank from the truck earlier in the year. While I was in there I bought new Fuel Pump parts online. However once they showed up, I found out the filter/strainer did not fit properly...
  2. MTsoul

    Build Little Green Monster - 1st Gen 4Runner

    More chassis just because: (primer then top coat) Plus leaf packs: I cut the overload shorter on each side. I didn't completely disassembly the pack, but just covered as much as I could. Then when putting back together, I sprayed fluid film, as that is what I had on hand, in between each...
  3. MTsoul

    Build Little Green Monster - 1st Gen 4Runner

    A lot of little things happed over the summer. Rear End: Prep, Paint, Assemble I finished assembling new bushings into the the Chevy 63s, good thing I have access to a press at work. I also finished completely welding in the new Leaf hangers to the frame. A few spots weren't perfect, but...
  4. MTsoul

    What have you been doing with your Toyota?

    Dang this thing looks awesome. Great work, sir! :cheers:
  5. MTsoul

    SPOTTED

    My schedule worked out just right to be able to hit up the Red Lodge car show on Saturday. Ran into a local, Mike, that has the FJ25. Plus a few other good lookers.
  6. MTsoul

    2026 Trail Ride Schedule

    In the spirit of kicking off the trail season for the club, here is a video I saw recently and thought it was fitting and relatable for most of us. Plus, I am a sucker for 1st Gen 4rnrs. (For those familiar with Toyota World Runners, the editing and voice over reminds me a lot of...
  7. MTsoul

    St. Anthony Sand Dunes - 4/25

    nice selection of pictures...they call me "Air Tacoma" ;)
  8. MTsoul

    SPOTTED

    Unfortunately, another one strikes. This is a good PSA! I drove by this last week, too, and my first thought was how did they get it back on the side walk and nice and square with the world with all that going on?!?
  9. MTsoul

    2026 Trail Ride Schedule

    Hey @N in N, while i am not sure I will be part of this club run in August, I know I can say the club would love to have you and your buddy join! Glad you reach out. I say keep your eye out on this 406 Cruisers section for greater detail on meet up times and locations. There should be a...
  10. MTsoul

    Build Little Green Monster - 1st Gen 4Runner

    Thanks, @REZARF . Yeah, it sure looks like we can get out there early this year. I doubt I will have this green monster all ready for the heart of the season. But I will keep pushing. I plan to do dual transfer cases and will wait to figure out drivelines from there. So, likely, I will have a...
  11. MTsoul

    Build Little Green Monster - 1st Gen 4Runner

    I had to laugh when I pulled the OEM shackles...I am pretty sure these are suppose to be round. I found used Chevy leafs locally. They had a fair bit of oxidation. I pulled the center pin and did my best to knock it down and clean. I have new center pins and bushings ready to go in, but I...
  12. MTsoul

    Build Little Green Monster - 1st Gen 4Runner

    Ok, the Runner has officially gone under the knife! Rear Suspension: Chevy 63s Over the last many weekends, I have been chipping away at this project again. I shifted gears and decided to start with the rear leaf setup. In general, I think I made a smart move and started my efforts at a local...
  13. MTsoul

    Black Hills Cruiser Classic (Deadwood, South Dakota)

    Great to hear you got a great event on the books. Unfortunately, I wont be making any cool trips like this, this year. I am just hopeful I can make one of the club's trail rides this summer.
  14. MTsoul

    SPOTTED

    Better late then never. This was downtown Helena a couple weekends ago. I was driving around East Helena too, the day before, and saw 4 different 40s, including the blue one with goofy wheels that I think @ttFJC posted recently.
  15. MTsoul

    Recommendation on reconditioning Leaf Spring Packs

    Hmmm, graphite embedded enamel would be new to me. I will look into that more. Thanks Drew, and maybe I will see ya tomorrow night at the meeting!
Back
Top Bottom