Recent content by mtnpig

I would be interested in 2 sets.

No Bob it's all 18 gauge cold rolled sheet stock.

It's been a long time between all the kids activities that I have been able to bang on any metal. I forced myself to work on something today and made some good progress on the drivers side front half of the rear wheel lip.

I have a set I can send if needed. If I remember right most of the studs snapped during removal. I have a second set attached to parts rig as well I could try to get off. PM shipping info if you still need them.

I talking the rear qtr exterior vents like in the post 2-3 above, my preference would be steel/Nickel over the original plastic ones.

I guess the exterior vents are next model and print?

Recieved mine yesterday. Thanks!

Thanks for doing this and the detailed instructions on getting them ordered.

The Mrs. got me this great hat and matching T shirts for my birthday last week!

I knew I was going about it all wrong. That's the best advise available anywhere on this site.

That looks fabulous good job!

I haven't read the referenced article from Scraps yet but I have never understood this logic. I have seen it posted a few times. With road crown and not being able to run a perfectly level road(I'm not a believer in flat earth). I am with the logic if it is reasonable, the hood shuts, and the...

Is or was Pigeaten printing these? Looks good.

Got a little closer last weekend.

Kartek is a pretty nice resource for offroad fab and car builds. Even better to be local and get to walk through the place every now and then, always find some of the stuff you didn't know you needed, until it is staring you in the face.