Recent content by mtnco

  1. mtnco

    Share screen shots of your OBDLink MX, Torque Pro, etc. configurations, or other similar products?

    Here’s what I’ve settled on, though I make tweaks from time to time. Coolant and trans oil temperature gauges change color at defined set points, from blue to green to yellow to red.
  2. mtnco

    Front Bumper Filler & Radiator Guard for Trimmed GX460 Bumpers

    Thank you for confirming!
  3. mtnco

    Front Bumper Filler & Radiator Guard for Trimmed GX460 Bumpers

    Judging by CBI’s photos and install video, my bumper filler and radiator guard are fully compatible. There are four available threaded holes in the GX’s radiator cross support, and I’ve left them all accessible for this reason (CBI’s design uses all four).
  4. mtnco

    Front Bumper Filler & Radiator Guard for Trimmed GX460 Bumpers

    Thanks. I’m located in Denver. As for sales coming up, yeah I’ll likely do a Black Friday sale.
  5. mtnco

    Replaced rear level sensors, new baseline height?

    Awesome, glad it’s sorted!
  6. mtnco

    Replaced rear level sensors, new baseline height?

    Sorry, going to rant for a sec: I use AI frequently (work and home) and asking it about this type of fringe situation would probably result in a conflation of information from various air suspension systems and/or straight hallucinations. Just not going to be a lot of relevant training data on...
  7. mtnco

    Replaced rear level sensors, new baseline height?

    Did you go through the ride height adjustment procedure in the FSM? It’s a physical adjustment of the sensors to set ride height. They do not adjust height separately side to side, but both height sensors must be adjusted so that they read the same when the axle is “parallel” to the frame. If...
  8. mtnco

    Screwed up Strut Intall (Factory Replacements...)

    This is from the FSM. Hope it helps.
  9. mtnco

    Build "Rednexus" - 2007 GX470 Build and Fabrication Thread

    I drove Tincup on Saturday! Plenty of RZR’s but all pretty tolerable. Of course, I didn’t think to get a pic of the GX with the sign.
  10. mtnco

    Media GX460 / Prado150 pic thread

    Beautiful day at 13,140 ft
  11. mtnco

    DIY Coolant Valley Leak Repair

    Yes, but not right away. First indication was my coolant reservoir would drop from F to L about every 3 months. Was like that for the past year or so. Nothing dripping down the bell housing until a few months ago. That’s when I started planning it out and gathering the parts and supplies.
  12. mtnco

    DIY Coolant Valley Leak Repair

    I went with the J2Hundy gasket and smeared gray RTV on both sides, per his instructions. It gave me more working time, which was nice, ‘cause I’m slow.
  13. mtnco

    DIY Coolant Valley Leak Repair

    I tackled the valley plate repair this weekend and this thread was invaluable. A few things worked well for me; hoping it helps others. 1. Impossible harness clip: I wanted to try unbolting the clip, like @Acrad, rather than breaking the plastic. I made some room to reach the bolt by loosening...
Back
Top Bottom