Recent content by mrwardy

  1. M

    Fresh Front end rebuild Issues

    Ok here is my problem.. I had some clicking in the passenger side birfield. I did the full rebuild and repack including swaping birfield sides. Well now the clicking is on the drivers side, so my question is can I order a new birfield and just pull that side apart reusing all the gaskets ect...
  2. M

    Real time help with axle oil seal!

    Keeping the spring in When I replaced the seal I packed the back side of the seal with grease to make sure that the spring was not going to go anywhere. Just a Tip to keep that spring seated.
  3. M

    Question for the knuckleheads...

    Greased up I just did the front last wekend and I used over 3 tubs of moly. and one tub of wheel grease. So I had 4 moly and 2 wheel grease on hand. ALso needed diff fluid as well. Plus a case of paper towels. Good luck!
  4. M

    Spindle Bushing Question

    delearship Yikes...Called the delear this morning and that bushing is $79 bucks man along with not letting me finish the front end yesterday it hitting me for a chunk of change for a little piece of brass. Does this part fail often or am I just lucky? Might have to give Cdan a call.
  5. M

    Spindle Bushing Question

    Ok... I have the front end apart.. putting back together with all of Cdans parts.. and the bronze spindle bushing on one side just spins freely:doh:... I was under the impression that this was supposed to be a tight fit..like the other side. Now my question is can I put this back together with...
  6. M

    New to me 96 LC

    Ok... I have been looking for a 80 series LC with factory lockers that I could afford, so I dont need to worry about the Wife and Daughter in the snow anymore (previous ride was a ford Escort).. Plus I will get to wheel it when camping exploring ect. It has 101k on the clock and needs some PM...
Back
Top Bottom