Fresh Front end rebuild Issues

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Feb 16, 2009
Threads
3
Messages
6
Ok here is my problem.. I had some clicking in the passenger side birfield. I did the full rebuild and repack including swaping birfield sides. Well now the clicking is on the drivers side, so my question is can I order a new birfield and just pull that side apart reusing all the gaskets ect. I think I will need a new c clip that will get destroyed removing the old birfield from the axel. I dont really want to spend money on all those seals again.

Thanks in advance.
 
Last edited:
Everything you are looking for is serviced separately from Toyota. I wouldn't neccessarily agree with reusing gaskets, but YMMV.
 
You can probably get away with not needing new gaskets. I would however have a new inner axle seal on hand.

Something to keep in mind- Take off the caliper and hang it. Remove the two piece wiper cover on the back of the nuckle. Remove the abs sensor, upper and lower trunions. Remove the snap ring at the end of the axle. Then remove the entire spindle/hub unit as one piece then pull the axle. Much easier and no need for lots of new gaskets.

Buck
 
You can probably get away with not needing new gaskets. I would however have a new inner axle seal on hand.

Something to keep in mind- Take off the caliper and hang it. Remove the two piece wiper cover on the back of the nuckle. Remove the abs sensor, upper and lower trunions. Remove the snap ring at the end of the axle. Then remove the entire spindle/hub unit as one piece then pull the axle. Much easier and no need for lots of new gaskets.

Buck

x2... Thats how we do it up wheeling:beer:
 
You can probably get away with not needing new gaskets. I would however have a new inner axle seal on hand.

Something to keep in mind- Take off the caliper and hang it. Remove the two piece wiper cover on the back of the nuckle. Remove the abs sensor, upper and lower trunions. Remove the snap ring at the end of the axle. Then remove the entire spindle/hub unit as one piece then pull the axle. Much easier and no need for lots of new gaskets.

Buck

Your getting pretty wise in your old age Buck. :clap:
 
Nice call on the maxi-pull!

On the clicking, don't get too scared of a little clicking. Mine have been clicking for 50,000 miles and the rebuild only slightly reduced it when I swapped sides like you did. Clicking while pulling away with the wheels turned for a street vehicle is no big deal. Put bigger tires on it and go wheeling and then MAYBE you'll eventually blow the birf. The part can click for years. So, if that's the extent of your symptoms and you just wheel once in a while on moderate terrain then you're fine.

DougM
 
Back
Top Bottom