Recent content by mleichty

Those actually look like the best thing I’ve seen. I didn’t look a lot yet, but were you able to determine if they are the correct diameter for the spring to seat correctly?

To be a little more clear, this is the piece I’m looking for. Front axle, sits on top and locates the spring. It may be more of a pain/cost to remove than trying to source something else, but thought I’d put it out there.

Happened upon on 80 front axle for a really good deal so I grabbed it, but the spring perches (just the round piece the spring sits on) were cut off. Looking to see if anyone has an old axle that’s headed for the trash that might be willing to cut the perches off for me? Let me know if you have...

If cost is not a major concern, the Clearview Easy Slide works perfectly for this situation. With a regular slide and the fridge on top of the drawers there was no way my wife could reach in, let alone see what was there, but the Easy Slide drops the entire fridge down to tailgate height with...

Inbox is full, but if TomH doesn’t take the lights, I’ll take them. Send me a PM if they’re still available.

Interested in pricing for a couple 80s and maybe a GX470 as well.

Any chance you have the rear trunk carpet piece in the lighter brown?

I do have actuators in all 4 corners. They are IP65. I got them from here: https://www.windynation.com/linear-actuators I originally thought I’d set it up to run from 2 switches (front and back), but they don’t run at quite the exact speed, so I ended up just doing one switch for each actuator...

I did hydraulic lift struts inside the vertical posts, and they worked ok, but it was kind of a pain and it was really hard to prevent binding. I ended up going to linear actuators and heim joints to mount the top rack and it’s so much easier and smoother now. Should have done it that way from...

There is always the porta bote. It’s a little different experience than some boats, but they fold easily and fit on your roof rack without much trouble. After having used both, I would much prefer the porta bote over a canoe or inflatable. Lots more space than a canoe or average size raft as...

Do you know what the rear springs are? Are they Js also?

Interested in a rear bumper for a 94 80 series

I would also be interested if another group buy got started.

Got mine done here: FIE Magnetos, Mechanical Fuel Injection & EFI, Fuel Injection Enterprises - http://www.fuelinjectionent.com/. They are local to me, but you can mail them in as well. Took about a week to get them done. I had similar results to TYM4FUN other than I had 2 that were about like...

Agreed. I just had mine out during a head gasket job and there was some evidence of gas around them and they were loose in the holes and the rubber gaskets were hard and dried out. I had them serviced and they got them all back to factory spec. New rubber seals and everything is clean and dry.