Not shown in the pics but I have just about finished welding in the quarter panels - no alignment issues so far. Solid as a rock once the quarters get attached to the rear sill bar…
I’m planning to use Al Jacobs’ pumpkin orange on my 74 project.
At least when first applied, the 304 Pollux Orange is a bit too bright for my taste. -
However based on lots of photo research it would appear that the Pollux orange fades out to more closely match Al Jacob’s orange…
My problem...
I’m planning to use Al Jacobs’ pumpkin orange on my 74 project.
At least when first applied, the 304 Pollux Orange is a bit too bright for my taste. -
However based on lots of photo research it would appear that the Pollux orange fades out to more closely match Al Jacob’s orange…
My...
I’m no expert, but I have changed globes on a couple of vehicles.
If the globe will not break loose with a fan clutch wrench, then just get a hammer and chisel and use the sharp part of the chisel
on the widest part of the globe turning the globe in a counterclockwise direction. After a...
So now the real work starts. I spent the last few weeks priming all the body panels and measuring /figuring out how everything goes together. Time to start cutting out the old…
my plan (if it makes sense) is to rebuild the rear of the tub while sitting on the frame. The frame has been cleaned and painted already by the prior owner who lost interest in the project.
everything is pretty good forward of the mid floor - I'll install new body mounts under the front...
perfect - thanks for the confirmation - heading on a road-trip this week to pick up a top and sides.
as you noticed, the rear sill has completely collapsed on my project - thankfully many of the parts for the rebuild were included with the cruiser - rear floor and sill, body mounts, new...
the amby doors look great, but I can imagine the leaks and flex they would add.
I was planning on using the hatch, and I have ordered a bolt-on tailgate which should strengthen the body structure (especially while I'm cutting out and replacing floors, wheel wells, and quarters...
Anyone...
So is it possible to adapt my '74 liftgate/hatch to a '79 top and cab sides?
Is the opening size physically different? If not it would seem to be a simple matter to add the proper support for the liftgate hinges and weld up the holes for the ambulance door hinges? (since I don't have...
Just picked up a '74 40 series - my first - It is a bit of a basket case but since I retired I have the spare time to rebuild her. (Pics in next post) First on the list is rebuilding the tub.
First questions for the group....
I'm missing the Top and cab sides - there is a set in...