Recent content by Lummie

These links look great too. Unfortunately the sway bar bracket on the rear axle is what failed on me the last time. One of the bolts ripped out of it's hole. Not sure if it was partially stripped from a previous owner.

Great looking product. I've had the rear sway bar rip out at different mounts the last 2 trips to Rubicon. Will disconnecting the front sway bar alleviate some of the flex that's being translated to the rear.

I removed the Metra harness and connected the Scosche harnesses to the harness that came with the headunit. Plug the new harness into the grey connectors behind where the headunit sits. Then unplug the factory amp that's located behind the glove box. After that you're done.

I know this is a pretty old thread but I just replaced my Metra harness from Crutchfield with the Scosche Harness and my stereo sounds like a whole new system! I've been driving around with tinny audio the last 7 years! Wish I had done this years ago.

Just tried this technique and worked on the first try! I used the ground for the factory horn.

I wish I would’ve seen this post before I installed my rack! Very clean install!

Did you try swapping the leads on the BD harness? Mine didn’t fire up either at first and then I switched the wires.

Sorry was trying to be humorous. Thanks again @eatSleepWoof for the inspiration to do this. I just finished the install and it was very straight forward. I was able to access the fog lights by removing the lower splash guards and going in from beneath the truck. Just to confirm, the brackets do...

Just looked back at your images. You are running ‘pq’ instead of ‘bd’ lights.

OP correct me if I’m wrong but could you have possibly mounted your fog lights upside down? I just got my set of BD lights and the tops of the lights have the BD logo and the wiring is towards the bottom. Also it looks like if you mount it in this orientation. That the bracket will might not...

Have you guys looked at this thread? https://forum.ih8mud.com/threads/disabling-the-ahc-and-avs-systems-no-warning-lights.1164357/page-13

Just spent the weekend running Rubicon and the skid plate held up like a champ! Thanks again for a great product!

This thing is so beefy! Thanks again for the quick delivery!

I think I just bought the last one. :)

Are those the Khann fender flares?