Recent content by lowtoe

  1. lowtoe

    Please help identifying a part for the rear hatch.

    Zipties ftw. I think it'll hold?
  2. lowtoe

    Diagnosing Chirp on Warm Up w/o Accesory Belt

    Any update here? I'm having issues with the same symptoms.... and my timing belt / water pump was replaced less than 1000 miles ago
  3. lowtoe

    Wanted West Colorado: Silver 03Landcruiser 100 OEM UCA or Running Boards

    Looks like lx470 and 100 series uppers are the same. I DM'd u bcarbs
  4. lowtoe

    SRS Code 1153 Seat Position Sensor Fix

    Just wanna say I had the exact same problem, so thank you for this post!!
  5. lowtoe

    Wanted West Colorado: Silver 03Landcruiser 100 OEM UCA or Running Boards

    I very much appreciate your response, but I might hold out to see if I can find some that are closer to me and have OEM ball joints (aka im a beggar and a chooser XD)
  6. lowtoe

    Wanted West Colorado: Silver 03Landcruiser 100 OEM UCA or Running Boards

    Looking for some OEM upper control arms or running boards for my 03 landcruiser (silver). Let me know if you have any. Thanks!
  7. lowtoe

    Rubbery Squeak in front left wheel

    honestly I would, but I probably don't live near you. I live in CO but I'm 7 hours from Denver
  8. lowtoe

    Rubbery Squeak in front left wheel

    Update: The squeak that started this whole thread is gone! But I still have a chirp somewhere, and I'll be needing to replace my CV's soon (I have new OEM ones, but haven't mustered up the courage to do them yet). So again, thanks to all that commented. You've all been a HUGE help
  9. lowtoe

    Rubbery Squeak in front left wheel

    Thanks again for your response. I have OEM parts all around, so I think my problem is the grease I pumped into there. I put it all back together with 0.00m gap, drove it around the block, and saw your latest post. I put a bolt in the middle of the axle as shown in your video, and wrenched on...
  10. lowtoe

    Rubbery Squeak in front left wheel

    Thanks so much for your comprehensive reply! Given your reply, I will probably end up changing the spindle bearing/brass bushing at some point. We'll see how it does when I get the hub all put back together. Speaking of which, I think I didn't get the c-clip set in properly last time, resulting...
  11. lowtoe

    Rubbery Squeak in front left wheel

    tyvm for your reply. My CV groove might be bad; I'll double check. I have replacement CV's but just haven't put them in yet. It does seem like I have some scoring on the spindle now that you point that out. I bought the SLEE spindle greasing tool, and I'm going to use that to see if it fixes...
  12. lowtoe

    Rubbery Squeak in front left wheel

    I guess if my snap ring wasn't set properly, the axle could have not been all the way in the hub, allowing dirt to get in? Just theorizing
Back
Top Bottom