Hi there,
I am having a similar issue but only when in H mode: L and N drive perfectly...but when going on H...the back gets really hard and it's like driving on sticks instead of bumpers :bang:.
Couple of months ago I added rear coil spacers (40mm) and it worked just fine even in H. Recently...
Hi there,
Just did an AHC bleed and now I have the back of my car really bumpy when in HIGH position. It's like if rear bumpers do not work and I am driving on some hard sticks :bang:
Btw...I went for an AHC bleed since I had to brake the AHC line to install the front shock spacers. At the back...
I used to have a sensor lift with no spacers for a while and its look and feel is definitely great.
One thing to consider: the height change will need a wheel alignment.
I recently installed heavy bumpers + winch...so I decided to go with rear spacers (and soon front ones too) in order to...
Some progresses made:
- Rear Spacers (40mm) installed
- Front and Rear ARB bumpers installed (with wheel carrier) - mudflaps still missing...
What's Next: Front Spacers... :eek: ...somehow I keep pushing it further....got to get that done sometimes soon
Hi there,
Finally got the front spacers...and planning for the installation.
I am wondering if AHC liquid will spill everywhere when I'll break the line... :eek:
Any recommendation on how to best do the job?
PS: I found the Front Spacers (Toyota part: 43136-60020 ).
How about the Rear Spring Spacers? I found a few: 30, 40, 50mm...not sure what size I should consider. Any idea?
Thanks everyone for your helpful feedback.
It sounds I have some true options now :)
- REAR - Spring Spacers
- FRONT - Front Coil Spacers
Would you have any specific link/reference to recommend for both rear/front spacers?
Thanks again. :)
Thanks everyone for your inputs. I would actually like to maintain the 2'' sensor lift...hence I would be considering:
- Spring Spacers for the rear...pretty straight forward;
- and for the front? This is the trickier part :(...how about the following options?
> lower shock mounts brakets to...
Thanks CJ3. I am wondering since I see many LC200 owners looking at lowering the AHC system pressure following a sensor lift or to better manage added weight. I must say that so far...even when heavily charged...I havent noticed any issue. I am just worried if doing nothing to it may cause much...
Hi there,
I have a 2008 LC200 and I am planning to prepare it for overlanding trips. I am considering adding Front and Rear ARB Bars (70 and 90 Kgs respectively) + Roof Tent (approx 80 Kgs) + Auxiliary LRA Fuel Tank (another 100kgs when filled). My LC200 is equipped with AHC (2'' sensor lift...
For the rear coil springs, I found a thread about someone using LC100 ones onto the 200 (Upgraded AHC suspension..). I would assume King Springs AHC KTRS-79 should work on LC200 too? Anyone tried that out yet?