Recent content by Kenneth Ferro

22r throttle linkage is sticking! I've used a small bungee to pull back on linkage to lower idle as a temporary fix... Stuck far north in Maine and need to resolve the issue before I drive 4 hr home! Has anyone had an issue like this with carb'd 22r linkage? Is the return spring shot? what...

This is a carbureted 22r, does TPS apply to this?

I'm noticing an unusually high idle when coasting or between shifts. If I blip the throttle it will kick down and idle normally. I'm sure this is common and would like to know how to address this situation! Thanks a lot in advance! Ken from LC

Hi all, I would like to install a snorkel on my 87' pickup. It has the 22R. Any recommendations on quality companies ya'll have used? What else should I overhaul on this truck to keep it water resistant as far as air and electrical? The truck is bone stock and I would like to get it overland...

Hey guys, 87' 22r intake manifold leaking coolant (slowly) seeping from lower section of manifold. It seems to be leaking from the gasket between manifold and plate below. What is the name of the plate it is leaking from so i can properly find the gasket needed? Also, what is a good website to...

Amazing guys, thank you. Yes, the truck is prestine but, in the end it's a truck that gets good use. She is a bone stock 87' with low miles on a quiet 22r. The slide bolt system seems simple and rugged enough for what I want. I will be driving her to panama come next fall. I'd like to make...

Ok, I figured that they haven't made a locking handle. I'll get creative with the welder to create a slide bolt system unless someone else has a good idea that is. Thanks phrogg4evr

Anyone hear of an aftermarket lock mechanism for my 87' pickup tailgate? I have locking cap and would like to lock tailgate too. Thanks Ken