Recent content by Jimthom

Thank you.

For clarity, the dignostic I refered to was the link in woodwars post of 2001LC's post describing how to get air out of the coolant system.

Woodwars and 2001LC, why would low coolant levels, and its effect on the temperature sensor, cause a loss of power? I don't see any explanation for this here. I also had a loss of power recently. It was brief, no codes an seems fine no. After finding this thread I recalled that the heater was...

From the Foreign Service article, the module appears to be a pulse width modulation (PWM) motor speed controller. These are common for DC motor and light power control. The speed is controlled by adjusting the timing or width of the pulses of voltage. The figure in the article shows just this...

Partsouq today for my 06 LC.

I understand now. I think you did mention this some where up above., that one could not get a baster in deep enough. So, maybe one could. But your reason for bleeding through the rear makes sense. Thanks.

Why do you remove excess fluid ( above Full line) by bleeding through the rear brake? Could it not be removed with a baster from the fluid reservoir itself? This seems simpler. Incredible write up. Thank you.

Just had the same, check engine light and VSC trac and VSC off lights. Found this thread. Resecured gas cap, disconnected battery for 30 min. Lights were off initially then came back on. 17 yr old gas cap. Put a thin film of oil on the gasket, resecured it. Lights off. Old gaskets might need a...

Well, yes, but used , scratched, and a thin market. Just wanted to move them on to someone who could use them. Thanks for all the replies.

Slee intermediate and belly plates, steel, used. Scratches and spots of surface rust, solid. $50 OBO. Not worth shipping. On Olympic Peninsula, Washington. Can help with transport for local offers. Come visit Washington this summer and pick them up.

Slee intermediate and belly skid plates, steel, used. No hardware. Scratches and small surface rust spots but solid. $50 OBO. Very heavy, on Olympic Peninsula, Washington. Not worth shipping. Can help with transport for local offers.

I heartily recommend Alfredo, near Corona. Knows his stuff, did a proper job, cleaned up the rust, used the correct rivets for the trim, and the noise is much better.

I may be a bit wrong on the details in my description above. The thin ring on the spacers face outward, the same side as the lugs The spacers fit over a similar ring on the hub, which centers the spacer on the hub. The ring and the machined ring on the spacers fit outward and mate into an...

Both front and rear spacers come from Spidertrax with the hub-centric orienting ring. It is the flange sticking up above the central open space inside the lug nuts. For the front spacers Slee has machined away some of the material from this ring in order to clear the protrusions of the drive...

XLX I started a conversation with you to discuss this further. Jim