Recent content by jessebee

  1. J

    1989 fj62 cranks wont start

    Update. Found the culprit. House cat climbing around the engine bay while it was in the garage with hood up knocked the intake hose off of the afm. Unmetered air caused it to die after cranking. Thanks for the input.
  2. J

    1989 fj62 cranks wont start

    I think I got everything plugged in. Sorry not familiar with CEL to answer that question I was looking in the fsm and most of that troubleshooting points towards the ignition system so I’m going to look into some of those things. Maybe the transmission dipstick pulled a plug wire or...
  3. J

    1989 fj62 cranks wont start

    Ok so here is the possibly unnecessary story. I removed my transmission and replaced the torque converter seal due to a leak. I finished bolting the transmission up last night and tried to start the truck and it will crank but will not start/idle. SO now I am trying to determine what I...
  4. J

    Help Desperately Needed Getting Cruiser Running!

    Haha that’s what I get for trespassing from the fj60 forums
  5. J

    What to look for when buying a 100

    I am going to look at a 100 series this afternoon is there anything that I should be wary of? It’s a 250k mile truck 2001 model and the guy is asking 7 grand. That’s all I really know about it. Any ideas on what to look for will be super helpful. I’m coming from a fj62 and I got burnt on it...
  6. J

    Help Desperately Needed Getting Cruiser Running!

    Check all your wires on your distributor and make sure you didn’t knock one loose. Seems like you aren’t getting spark and flooded the engine. Check your dipstick and see if your oil smells like fuel to see if it had been flooded. Might need an oil change after you get it running. same...
  7. J

    A440f shifting issues when cold

    same thing happened to mine and sad to say it was toast in less than 200 miles after these problems started. Start looking for a transmission
  8. J

    So I swapped my transmission... but....

    Using the original flex plate. I wonder if I could have bent it when I bolted the tranny to the engine with the torque converter seated improperly. I will pull it off there and see if it looks screwed up.
  9. J

    So I swapped my transmission... but....

    My current agenda is going to be remove and inspect the flex plate. Then I will get a closer look at the starter. Maybe it got some trash in it? Idk if anyone has any ideas please let me know.
  10. J

    So I swapped my transmission... but....

    It is seated correctly now as soon as I couldn’t turn the engine by hand to put the bolts in the torque converter I stopped, dropped the transmission and seated it properly. Anyways I charged the battery tried it again same result. So I dropped the transmission again and i can actually see the...
  11. J

    So I swapped my transmission... but....

    Yes I filled it with 2 liters plus a little bit extra until it ran out the fill hole
  12. J

    So I swapped my transmission... but....

    So I swapped my transmission on my 89 fj62 and I got all the fluids topped off and went to start it. It fires off and then there is a horrible metallic screeching and then it stutters and dies. I am hoping the battery is sort of dead and causing the starter to hang up. but I am kind of...
  13. J

    1989 FJ62 auto transmission help

    What kind of mileage do you get? Is it good on the highway?
  14. J

    SOLD Ca 92 fj80 parting out. gold/beige with brown cloth.

    Looking for a A440
  15. J

    SOLD Ca 92 fj80 parting out. gold/beige with brown cloth.

    How is the transmission? does it have an A440f or A442?
Back
Top Bottom