Recent content by JC Connell

I tapped both the ports on the compressor head to accept 3/8" NPT fittings. I put an male quick fitting on one side and a blow off valve on the other. Pressure never builds on one side. I noticed that the gasket between the compressor and the head has a center rib. Should I remove or otherwise...

My goals are a tankless setup and to reuse as many of the factory parts as possible. I have a 60a breaker I'll be installing, but I need a switch. Trying to reuse the factory switch resulted in continuous on/off cycling. Sounds like you might have some more experience and direction than me...

It looks like the switch has some adjustment built in. The pressure relief valve included is 150PSI. I wonder if I can adjust the switch to cut out above 150PSI and have it run indefinitely? What are some other switch options if I can't get this to work?

I'm looking to permanently mount my Puma. I don't plan to use the tank, at least not initially. I'm looking to reuse as many components as possible. I have retapped one compressor orfice to accept NPT 1/4" threads, installed a few elbows and rearranged some ports on the factory pressure switch...

I arrived at this build thread after your DIY roof rack post on Reddit. I have since read your entire build thread and imagined how to modify your ideas to my 2004 WJ Jeep. I'll never admit it on a Jeep forum, but I even considered selling the WJ in favor of picking up an 80. That idea came to a...