Recent content by ivn351

  1. I

    FJ62 Diesel Conversion - Aussie Build

    Like a bought one!
  2. I

    FJ62 Diesel Conversion - Aussie Build

    What’s the best part about doing a 2H swap into an FJ62??? Packing up the engine hoist away because you won’t need to pull the f’ing motor and box out for the millionth time ever again!!!!
  3. I

    FJ62 Diesel Conversion - Aussie Build

    No, definitely going all late model throughout (except the engine!!!!)
  4. I

    FJ62 Diesel Conversion - Aussie Build

    Yep, see next post (a bit slow in posting I am!) Thanks for contributing mate you've been a great sounding board for me so far.
  5. I

    FJ62 Diesel Conversion - Aussie Build

    So I cleaned up the mounts a little, then I used the reference points with steering box bolts on the RHS to mount and punch in some holes in the chassis to mark out where they sit. On the LHS, i sheared the head of an appropriately sized bolt, threaded it into both the chassis and the supplied...
  6. I

    FJ62 Diesel Conversion - Aussie Build

    So engine mounts had to come out. If gearbox crossmember was modified to make it suit, i'd have a gear shifter pushed forward inside the cab, too close to the dash console for my liking. The other thing that played on my mind was engine height, distance from the firewall, angles, clocking, all...
  7. I

    FJ62 Diesel Conversion - Aussie Build

    Seemed to fit OK, but, of course, the gearbox didnt line up, so i had a look at what would happen if the gearbox was in place
  8. I

    FJ62 Diesel Conversion - Aussie Build

    Thought it time I resurrect this thread and get on with the job. Not much has happened since last post, but I have decided to focus on the engine swap particulars. So I figured while the 2H from the HJ60 is out, i'll grab the 2H from my 1981 HJ47 project and use that as a donor for the swap...
  9. I

    Build Barons white FJ62 log

    It's been great watching this thing come alive, credit to you! Enjoy!
  10. I

    FJ62 Diesel Conversion - Aussie Build

    Not sure I can get that mating surface much cleaner than that.
  11. I

    FJ62 Diesel Conversion - Aussie Build

    What sealant did you use? Also, I’ll definitely be checking the engine block deck and head for straightness and if outside of limits I’ll take to it with the sharpening stone. I’ve put about 6 hours in on the oil cooler housing engine block side but that looks to be the worst so far. I’ll let...
  12. I

    FJ62 Diesel Conversion - Aussie Build

    Some pics of the dismantling. I realised that i had set the engine to 11deg mark BTDC rather than TDC, so I put some white-out on the aligning marks, along with the injection pump "window". I also put some white out on the injection pump housing that is fitted to the timing case, to make sure i...
  13. I

    FJ62 Diesel Conversion - Aussie Build

    so bit of an update.... things have been moving slowly, but moving along anyways. The motor, gearbox and shafts were removed from the HJ60 and I have partially stripped the engine ready for gasket / seal replacement and a bit of a cleanup. The motor looked to be in good condition, no oil gunk...
Back
Top Bottom