Recent content by Ironbuck

  1. Ironbuck

    Replacement Seats - Powered Non-Toyota Seats

    I had a question about replacement seat options. I have seen the threads about using WRX seats and like. Has anyone tried putting BMW seats in their rig. Could you use the power and switched to run the seats if you could get a mating harness wired in? Something like this? 04-10 BMW E60 M5...
  2. Ironbuck

    Pulling out Old PCV valve

    This is great input, thanks for chiming in!
  3. Ironbuck

    Pulling out Old PCV valve

    Wanted to change out the PCV. Boy is it snug and hard to pull out. Any chance I break something if I pull too hard? Any advice? Should lube with oil when I reinstall?
  4. Ironbuck

    Need New Exhaust

    Is there any documentation for this setup, I would like to know more? I need to replace my cats/y-pipe but I already replaced my muffler.
  5. Ironbuck

    Power Steering Line Confirmation

    Any thoughts about the pump shaft not turning freely or some of the others questions?
  6. Ironbuck

    Power Steering Line Confirmation

    Questions about rebuilding the PS pump: So I am putting things back together and some things do add up between the write-up and the assembly diagram. First, when lubricating the assembled parts are we use the ATF oil or penetrating oil? FSM says ATF. Second, when I am putting in the pump...
  7. Ironbuck

    fj80 and lx450 ps pump rebuild

    So I am putting things back together and some things do add up between the write-up and the assembly diagram. First, when lubricating the assembled parts are we use the ATF oil or penetrating oil? FSM says ATF. Second, when I am putting in the pump shaft and bearing: shouldn't the shaft be...
  8. Ironbuck

    fj80 and lx450 ps pump rebuild

    This seems like a great question, did you ever get a direct answer?
  9. Ironbuck

    Power Steering Line Confirmation

    I miss spoke. The fluid was coming out of the back thru the port that I belief may be for pressure relief. Can someone confirm if that is what that port is for. Can I try to fill and bleed the system or is this pump shot? The O ring is there.
  10. Ironbuck

    Power Steering Line Confirmation

    I tried bleeding it again. All the lines appear correct. I think the new pump just failed. Fluid is pouring out the front. Great! Would this be an internal seal? Was due to not bleeding it correctly?
  11. Ironbuck

    Power Steering Line Confirmation

    I really appreciate the feedback. Maybe a I can take my brake bleeder and drain the system and fill and retry to rebleed. Can some one send me a picture so I can verify if I should reconnect my hoses not hedge my bets.
  12. Ironbuck

    Power Steering Line Confirmation

    I did not turn the wheel 20 before turning it on. I was doing it while the car was running. Do you have any input on the orientation of the hoses? I can't tell from the FSM.
  13. Ironbuck

    Power Steering Line Confirmation

    I was working on my power steering. I replaced the HP line, pump, and the silicon for the lines that from the gear box to the cooler and from the cooler to the reservoir. I started it up to bleed the system last night and it ran awful. The steering was loose at first and then began to...
Back
Top Bottom