Recent content by hudsonman44

Nevermind…. Got impatient and tried to pull the oil pump… the pulley is bolted to the pump. I had to break the baring apart, as there is a cap bolt that you have to access through the pulley. I was able to poke a 7/32 Allen wrench through and get the last bolt and remove the oil pump with the...

I have a 2uz I’m swapping, and have just started with the timing belt/water pump and the bolt for the #2 pulley is stuck and stripped. I’ve tried welding a larger nut on but because it’s recessed in the pulley, I can’t get it to weld. Is the pulley bolted to the oil pump, or to the block through...

Hey guys, I recently picked up a 2005 with 300k miles and constant ticking from the top end... previous owner thinks he hydro locked it when cleaning out the valley. I ended up finding an engine/transmission with under 150k miles and decided to just swap the engines rather than diagnose what is...

I’ve been looking at this switch panel and am wondering what the trade offs between the IGBTs used in this one vs relays used in other solutions?

I ended up using washers to bump it out. I had to trim the mess out of the bumper and remove the backup lights. I noticed that Dobinson recently updated their website to say that 2014 and newer models require substantial body modification.

No caps, but I think some of this is the panel flaring out because it is being pushed in by the swing arm stanchions. Still waiting to hear from Dobinson, but assuming I may have to live with it and consider fabricating new side/corners for the body panel. I did study the pictures GX4OR's...

Hey guys, I'm almost through my build and am currently tackling installation of a Dobinson dual swing out rear bumper. I have run into a problem with the fitment and have contacted both Dobinson and the store I bought it from, but am hoping someone here can weigh in as well. This is for a 2017...

How did you attach the proximity sensors?

What is the experience switching between CarPlay and climate control?

Where did you get the skid plate for that bumper?

Mine seems to be working now. I had the CAN-IN2 adapter plugged into the AUDIO-OUT slot (B5 instead of B6) Also was able to reuse the original trim with a little modification. Much better fit than the trim that Phoenix sent

Son-of-a... looks like you are right. I must have spliced into S7 :(

Sounds like I need to trace the wiring from the rear speakers. The previous owner must have done something funky

Thanks for the feedback. I had studied this picture from previous thread a number of times in preparation for the install. The problem I'm having is that my S6 (connector in the left of your pic) does not have the four wires next to the blue circle. Those should be pins 3, 4, 10, and 11. I...

to clarify, I have plugged both the S7 and S6 connectors back into the ML amp