Recent content by hrwiv

Here is the poke

Agreed! The +25 offset and Bead Grip are why I went with the Method’s in addition to that being the lightest possible set up I could find, with 35s, sticking with the 18s. All the 17s I could find were roughly the same weight as the 707s which would have been fine if the 35 inch tire sizes meant...

Ayyy a fellow Florabama bro! +25 offset which on the Hundy puts the sidewall just a smidge past the fender. I was running Tundra 5-spoke steelies with spidertrax spacers for about 9 months. Those came out at +28 roughly so I knew the +25 would be good to go. Got rid of a bunch of weight with the...

New Method 707s 18x9 wrapped in year old Nitto Recon Grapplers, 285/75r18, with @cryptyk center cap extensions.

New Method 707's wrapped in 285/75r18 Nitto Recon Grapplers I've had for about a year. @cryptyk supplied center cap extensions.

@Exiled Apologies it has taken me this long to reply I've been incredibly busy with work. I'm finally getting both my steering rack bushings replaced and the Eimkeith PCK installed in about a month. I also found that when I got a set of Method's in 18x9 recently, with my 285/75r18s, that the on...

@cryptyk Thank you so much for getting me a set of these so quickly! Here's what Method 707s, in matte black, with +25 offset, and 285/75r18s look like with the extended center caps. On the 707's the extension makes the cap completely flush with the inner lip. I was a little unsure if these...

@Rednexus How long did it take for your Ultra Winch RDX to clear customs? I already received my accessory box and seems customs still has the actual winch body.

Are there still any plans for a front skid to pair with the creeper? Apologies, in advance, if I missed some info and didn't search throughly enough.

Just a heads up seems like the windshield part number has been superseded by the following part number: 56111-60292-8N

Success! After much searching it seems Suntek Infinity OP is probably as close a match for the factory privacy glass, mirror finish, that we can get with a modern tint. Setup Details: Front Doors: 20% Suntek Infinity OP Rear Glass: 15% LLumar ForumlaOne Pinnacle Windshield: None (getting...

Forgot to mention…wheel bearings are almost brand new done roughly 6 months ago.

Thanks for the input, really appreciated! Hand on heart the rake unloaded is 2.25 inches and hasn’t been less than 2 inches in over a year. It is obviously less when loaded up for a long trip but even then it’s never been less than 1.25 inches of rake. I’m pretty meticulous about measuring...

So I went to Discount Tire and got them to give me a printed read out. This is where I’m currently at: From what I’ve read from Post in thread 'Steering Wander/Poor Handling? HELP' from Abuck99 I need to be adjusted to over 3 degrees. Basically getting it as close to 4 degrees as possible is the...

The current rear height is 23.25. Rake is 2.25 unloaded and when loaded down for a trip it’s 1.5. That’s after we lowered the front. Before we lowered the front the rear was at 23, the rake was 2 inches unloaded, and 1.25 inches loaded for a trip. This is where I’m confused because I don’t think...