Recent content by Hinterland

He is, but mostly just direct I think. I will tell him to check his DM’s.

Anytime, Good Luck!

I did a write up on having my local upholstry shop dissasemble my 3rd row and rebuild my front seats with the panels. They had to use a piece or two from somewhere else because of some of the panel sizes required for the fronts that aren't on the 3rd row. Don't know how to link it to this...

Still available?

Im headed down that way this weekend. Still available? Also think I responded to your craigslist ad about the powder coated ones too?

PM sent

Still for sale?

Pm sent

I did a post on it on here. With pictures

I redid my front seats by using the 3rd row. My upholstery guy charged $400 total for both. Only had to use a couple pieces not from the third row for the long bolsters on the fronts. 3 years of use and they are working great. Much more affordable.

Hi, I used a ratchet strap to pull the body into position with the pan hard removed. Then put a straight edge up the ground against each tire and measured to the same point on the body on both sides until perfectly equal. Then set the pan hard length to fit and installed. Then took off diagonal...

I had the same issue when I built my Hanna Quality rear bumper. But the factory resonator I removed was too big to go back on well. I went to my local muffler shop and he had a brand new resonator sitting around from a dodge 1500 that came straight from the dealership for aftermarket exhaust...

Hi, We are based down in Santa Barbara county. Owned and run by my wife and I. And we presently offer the heaviest canvas of any North American Company. If you want heavier canvas you've gotta get an EZawn. Our website is hitents.com. And we are running a black friday sale of 10% off site...

Sold