I have an extra set of oem aluminum mag wheels. Id like to powdercoat them, and that process is something I'm just learning about, but everything points to good surface prep leads to good results. As with anything new im a little unsure how to proceed. Some sources say chemical strip then fine...
I have a 72 fj 40. Im sorting out my wipers and my slave side has a bent tip on the end of the pivot where the nut holds the wiper arm on. I have a spare gear, but the sleeve is a mess, but the post with the gear is good inside. I cant get the gear with pin out. I've tried heat, penatrating...
I came up with a lazy way to recondition my warn hub springs. Basically once I got the rivets cleaned out enough to pass an Allen key through, I put one through each rivet and compressed them with a couple zip ties around the gear and plate. Put them into the warm ultrasonic cleaner and kept...
I pulled my hubs of my 72 fj 40, driver's side was jammed in free. Only thing I could really find wrong was the springs were absolutley mangled and twisted. After a dozen trips through the ultrasonic cleaner the pins that the springs go through, freed up enough to rotate get it kinda straighten...
That would be perfect is i could find a .05mm shim. I would love to measure and check with the sst, but my spindle bushing look so happy and perfect I'm not willing to risk the trip in and out at this point. I did measure the ball and knuckle with the sst and did the math in inches. Original...
New bearing and races. No seals installed yet. I had a pack, now it's half a pack because I put new ones on top. Started with a .5 +.5 +.2 on top and 1.0 on the bottom. Replaced top with same, reused the 1.0 from the bottom because it was flawless. Got 6 lns preload on the arm. Went back and...
My driver's side came apart with 1.2 mm shims on top and 1.0mm on the bottom. Put everything back together as it came out replacing the mangled top shims but measuring the new ones to be the same going in. Got 6lbs on the pull scale. I am running 33x12.5 tires and feel this is a little low so I...