Recent content by HeritageCruiser

How are you guys resizing pictures to post on this forum? I would post some pictures but says the files are too big I just know that a slotted hole with a bolt through is going to allow the part to eventually slide to the end of the slot. This is a recovery point that is going to get jerked...

Whats the best way to reduce image sizes for this forum so I can post pictures from my Samsung S21? Thanks in advance.

I could weld the recovery point brackets to the frame in a few spots which would keep anything from moving and I may do this.

My problem with the recovery points is they are held on with one 1/2" bolt on each side. The recovery point bracket bolt holes for the 1/2" bolts are slotted and you cant slide them to the end of the slotted hole because of how the bumper and wing parts mount. So in a hard pull if the 1/2" bolt...

I own a shop and I would never have my guys install this bumper, we would lose our ass on the install or the customer would be unhappy with the install price.

I bought a Dissent Offroad rear bumper with dual swing arms. I'm not very impressed with it. Anyone else have one or tried using the recovery points on the rear bumper? I personally don't think I trust the recovery points for any type of hard pull and will just use the receiver hitch. I'm...

I had a feeling it was something along those lines, nice.

I'm wondering about the new OME UCA's and if they are better than the SPC, TT or BH? The OME's have that new GIIRO flex joint that I wonder how it will hold up over time and if it helps much with flex? Also the OME says up to 2" lift but maybe they will work fine up to 3"?