Recent content by hcaZ

Lincoln 200 squarewave. Can’t beat it for the price.

80-90?

I disconnected fuel sorry, meant 78.

I have everything on your list except brake booster and radiator. Flushed radiator and pressure checked with good results. I'll take a pic tomorrow!

Thanks. I'm having trouble finding hoses. I have 5k to spend and need to spend it all or she'll start trying to sucker me out of it haha

Thanks! Wasn't sure on the fuel pump but definitely wouldn't hurt.

Clearly said I'm pulling the trigger on this "tonight". Wanted some suggestions on what else I might need befor I put the order in.

Thanks! Knocked out a big sidejob so my wife's letting me do what I want with it haha. I just don't want to forget anything. Also ordering a new set of radiator hoses and a water pump. Not sure if I need the water pump with the oil cooler or not though? It's a 1968 with a 2f, completely stock.

Hey everyone! Just wanted some experienced eyes to take a look. 1978 fj40 ran perfectly but then it sat for 10 years. Sat covered. I'm going to order all of this tonight. Anything I'm missing? Thanks!

Thank you. That is exactly what I'm looking for. I'm just wondering what other modifications will have to be done as well. Steering, brake lines, rear end or driveline modifications, stuff like that.

Do you have any recommendations on what springs I should use? I would like to also do a shackle reverse when I do this. By doing a 4" spring lift what other modifications will need to be made? Sorry for all the questions but suspension is not my strong point.

So I'm looking to fit 35s. I would like to do this hopefully without having to do a soa swap. Iv looked around and haven't really found anybody who has gone into detail on what they did to make this happen. I'd love to hear any and all suggestions on what route to go with this. Thanks everyone.

As a welder/fabricator myself, your planning and attention to detail is impeccable and I thoroughly enjoyed reading this post and am looking forward to watching you complete your project.

San Leandro. I should be able to get it to pass smog, and that is my plan. I'm just really torn on the direction I want to go with my project. Will this stock motor reliably take me to Tahoe on 35" tires? I've never even heard one run yet haha. In fact I've only seen one other, ever in my life

I'm going to drive it around like it is while I'm building the other chassis. That way it's only down while I'm swapping the body over once the other chassis is built how I want it.