Recent content by hawnzilla

Just one piece of advice, if the vehicle is in motion keep your arms inside at all times! Do not reach out side the vehicle for any reason, even if it is tilting. Easy for a limb to get torn off, crushed or snapped in half. Please please keep your windows up if you can't keep your arms inside...

Thanks I didn't realize there was a thread already!

Can we add settings we run for adjust(able) shocks to this Thread? Dobinson MRA 6" Adjust Shocks Front HSC 6 LSC 8 REBOUND 8 Rear HSC 6 LSC 10 REBOUND 8

The color is Anthracite. All the badges and trim on my 1997 CE where same color.

??? Anyone can buy that steel. You or I can get it for maybe $150-175. Maybe less I can't tell thickness. You need to step your game up and look for better sources.... Look for local metal suppliers, you can get hell of a lot cheaper than big box retailers or online. The prices I mentioned...

Good luck going into home depot or Lowe's and buying a 22 ft section of 1-3/4" .120 wall DOM tube. Good luck buying 22ft of DOM online for $88.

I second this comment! I really wish I changed mine but was time constrained. I decided against doing it because they were unfortunately rusted to the point where once you touch them there is no turning back. It would of been quite the task. Since they were not leaking and not currently giving...

I am super suspicious of those eBay ones. It was $88 for a 22ft section of 1-3/4" by .120 wall. It would take all that and more to create those. Then if you factor in labor cost and profit.... Doesn't add up.

They are all the same size (can confirm 94 is same as 97). Probably 20 years of crud in them though. They likely need cleaned out, that was the case for me. I think they were M8x1.25.

I highly recommend building your own, its a fun intensive project! Take a welding class at your school or local college and ask to do this as a side project! Cost is much cheaper as well. I built 2 sets, one for a 97 one for a 94. I believe it was right around $440 for 1 set (paint not...

Whoa cow boy. check fuses first. especially the EFI fuse.

Car shot and stuffed with bump spacer below. Also shot where it was rubbing the flare before trimming. Trimmed picture is previous post. And yes spacer is 3d printed out of ASA. Has about 1/4" above the wheel to top of inner wheel well. The bump stop was compressed a bit. It would need to...

I went 35s stock suspension for now. Read different things here. Figured it depended on each person's skill level. Just went for it as I know I could easily make adjustments afterwards if I needed. The guys at the tire shop laughed at me. I told them just do it. Left them with their mouths open...

Impact Driver works great, doesn't strip it. If you have a stubby one it fits in no problem. You will laugh at how easy it is afterwards and wonder why you never thought about it. https://www.lowes.com/pd/Kobalt-24-Volt-Max-Variable-Speed-Brushless-Cordless-Impact-Driver-1-Battery/1000604923...

Turtle wax label and adhesive remover. plastic razor blade scrapper for the tough bits (can find on amazon, $6-10 for 100 pack).