Well guys. I want to thank everyone for all the help. Especially @2001LC. Problem solved. I repaced all spark plugs and coils. Everything else checked out. Running like new. Sooooo smooth. CEL is long gone.
All the SPs were barley tight. With a lot of AS on them.
Glad I caught it early. Very...
Looks like AS was definitely used when my plugs were installed. I'm am going to remove them all, do the spark and compression. And install new ones without AS. Based on the condition of the #3 plug i removed comapred to the #1 i think this may be my issue.
1.No oil on top of tube seal. The oil you see on the picture is dry and sticky. Not wet.
2.Spark plug could be tightened a bit more. But since I don't have a torque (on order) I didn't want to turn more. But definitely not tight to the right.
3. Electrode dry and in perfect condition
4. Didn't...
Maybe backing out? Looks like my guy added anti seize to the threads. Unfortunately I dropped the coil bolt. Removed the underbody trays and no dice. Can't seam to locate it. Maybe went into one of the holes of the subframe or control arms. 😬
The thing is it drove just fine in January. The last time I drove it. It sat on a battery tender since then and when a attempted to start it a week ago....after doing the heater tees. I got these codes.
Again, first it was a flashing p0301. I cleared it did a restart. Again p0301.
I drove it...
Thanks for the write up. I know there want any stop leak added since I had all that work done and provided the oem coolant and gallons of distilled water. Nothing else has gone into it.
Regarding the head gasket. What are the best locations to be able to see it. I havnt had any coolant loss...
I don't have any froth. Oil filler cap and filler neck are clean and lipstick shows clean oil as I just changed it in January.
I was asking if my coolant looked as if there may be a head gasket leak.