Recent content by Gamer

Not sure if this helps, but here ya go. There are some pics and some folks in there with it, so maybe that's your breadcrumb trail https://forum.ih8mud.com/threads/arb-rear-bumper-no-swings.1280053/

1.25" spacer, rubbed on the mudflap when in full turn. Some people will cut that, I just removed it and put the screws back

Here's the mid install comparison. I did spacers, rotors, pads, new wheels all around today, but this was the only pic I took. Now to address rubbing and work on blacking out s***. Edit: Ha, looking at this pic, I'm messy af. I have stuff all over the place, but whatever.... it all went back to...

Picked these up from a week at NVcoatings in Chantilly Va today. They're standard Tundra takeoffs, but media blasted and powder coated satin black.. I have DBA rotors to install this weekend, fresh pads, and new kicks. I went with 275/70r18 BFG KO3s. Not sure where I'll use the toyota logo (I...

I didn't do additional verification other than the standard shimmy the tire/wheel north south and see if it wobbles and the odd humming noise from the left front. It seemed to appear around 47mph, and faded when i turned harder to the left at speed, causing body roll to pull weight off of that...

@gaijin On a 2015 LX570, what would be the recommended cold tire pressure for these tires/wheels? LT275/70R-18 BFGoodrich All-Terrain T/A KO3 E on Toyota 18" tundra rims (I don't think this information matters) I used the calculator you posted and got this (which I hope is right, but should be...

Dropped off some Tundra 18" wheels with NVCoatings in Chantilly Va for satin black treatment. BFGKO3s ordered from TireRack and incoming to the shop for a complete look/feel/capability upgrade. The Kuhmo Crugen 71s on 20s are going to the basement. I might eventually add some other rubber to...

As a previous owner of a BeatSonic carplay module in my GX460, I installed a Hamilton unit in my new to me 2015 LX570. I have the phone echo mic issue that I need to get sorted, so I'm glad to come across potential fixes for this. I have been working with Hamilton support for a different issue...

Spent an hour and a half replacing a driver's side front wheel bearing assembly. I had an odd vibration and noise that would start around 47mph, turning to the left at speed took pressure off of the drivers side and the vibration and noise lessened. Not a hard job, and I had extra parts (lug...

I can say that the Hamilton kit was a really easy install, so is the Beatsonic (I have installed 3x and uninstalled 1x on the GX platform). The trim pieces on the LX took a few mins to figure out, but this one is a good one to start with. Lots of room under the dash and cables have a lot more...

I had this installed in my GX460, but I recently sold the rig and went to an LX570, and this unit is not compatible with that ride. I paid full price for this unit from Beatsonic, but I am looking for 625 shipped conus. It worked perfectly and updated my rig to a much more modern feel...