Recent content by evicta

Hi all. I've got a 1991 3FE Land Cruiser and I recently replaced the fan shroud with a new OEM one. The fan will tap against the shroud every once in a while. I took a look around and I've got a decent sized gap on the driver's side where the fan shroud meets the radiator. Does the fan shroud...

Hi all. I've got a '91 FJ80 with the 3FE and I am trying to troubleshoot my RPM when trying to drive uphill. I've posted on these forums before but I am now on my second '91 FJ80. Whenever I am trying to drive up a hill, I can only reach about 2500 RPM with the pedal to the floor. Dropping it...

Inside the distributor looked clean and the pickup coil resistances were within the FSM specs. Unfortunately this entire week the weather has been nice, cloudy, and a little rainy so the landcruiser has been starting up. I can confirm that there is fuel during the no start condition from a...

I replaced the igniter with a used eBay part 89621-12010 a few weeks ago. However, the one that originally came with my 1991 Land Cruiser was the 89621-30010. A quick search mentioned that the 12010 was compatible. Did I screw the pooch by using a different part number for the igniter? I'm...

Haven't made more progress but I have some more things to report. I installed a pressure gauge on the cold start injector. It's always getting 40 psi whenever I try to start it whether it's the starting issue or not. I have not had a chance to check for spark yet. I dropped off the land cruiser...

99% sure it is plumbed correctly. "Tank" is the line going along the frame and "Purge" is the line going to the VCV? When I open the gas cap, there is no form of differential pressure anymore. I've also tried starting it with the gas cap on or off. Banjo bolt was opened when I was having the...

I've been traveling for work lately so I haven't been able to put as much time troubleshooting. The issue seems pretty consistent. Starts and drives great first thing in the morning. Then when the sun starts coming out, the LC cranks, starts up, tachometer goes a few hairs over 1000 rpm, and...

I’ve got a 1991 FJ80 which I’ve had for a few months and know very little history about. I would say that I have done most of the general maintenance or suggestions that I have seen throughout this forum/FSM & tried to use OEM Toyota parts as much as I could. Spark plugs, wires, distributor...

Hi all. I put in Wagner 9011 bulbs for my low beams in September of last year and they were working great until recently. Over the weekend my low beam headlights went out. The two 15A fuses were good and the relay looked good. High beams were still working. On both the driver and passenger low...

I replaced the pre-filter with a Delphi FS0087 and put in a new OEM clip and gasket as well. The throttle body was cleaned and I tried recalibrating the TPS when I had it off. I drove a shorter trip from Nevada to Sacramento and back. It went up the mountain without any jerks or any feeling...

Hi all. I have a 1991 3FE FJ80 Land Cruiser that I bought as a winter beater with basically an unknown condition to me. I've been wrenching on it for the past few months and I think I'm at the point where I'm mostly happy with how it drives. Relating to the engine here is what I've worked on...

I picked up a cheap 1991 80 series and I was getting around to replacing all the shocks with the Tokico ones. The fronts were easy but the rears are giving me some difficulties where it has a bit more rust. I can't seem to get the bottom bolt out and I may have made it worse. A 17mm socket...

I'm interested in buying an ARB front bumper for an FJ80. I travel around a lot and can pick up in most parts of California or Northern Nevada.