Recent content by euclid

I thought so too but the end of the sector shaft on the new box was almost 2” shorter than the My OEM steering gear box had the variable rate steering on it which adds some overall length to the gearbox. The 105 box is shorter. So it made a gap between the sector shaft and intermediate shaft...

Hey folks hope someone can help me sort something I'm working on. My DD 1996 HDJ-81 has been upgraded with the following OEM parts: 44320-60171 vane pump 44110-60202 Steering box - 105 45411-60350 PITMAN arm - 105 To install these I had a local machine shop extend the intermediate...

@Will Van how did this work out? I’ve got an eBay winch cover and hope to mount a M8K warn. Found this thread after the horible freight plate mount ended up too low to use the cover. Sent Jason a message website says they are on break this week.

Thread resurrection. Fj80psi y sent you a PM

Super helpful post thanks for making it. Just fyi/ documentation CO is doing LHD boxes only not RHD boxes they dont know when they will have them back.

Those are RHD 105 gear box and pitman arm? I'm on the hunt if anyone has a lead. Already asked Dave.

Also searching 1996 JDM HDJ81 wiring diagram and becoming confident the diagram is only in the Japanese FSM wasn’t published in English based on this post: https://forum.ih8mud.com/threads/factory-service-manuals-for-japanese-models-ie-hdj81.1257288/

1996 JDM HDJ81 1HD-FT When the directions say apply 5V, what is the power source? Is this a multi-meter function that I’m unaware of? The FSM makes the battery look like a 9Volt. Best I’ve come up with so far is to build some resistors to put on a 5V but i hope the solution is simpler than that.

What kind of battery or tool does one use to apply 5V? Is a this a multi meter function?

My 1995 JDM HDJ1 1HD-FT came in with EGR stuff

The The shop that rebuilt my pump sourced the necessary rebuild parts for the pump. Same for injectors.

Seem really elementary like I’m missing something obvious but I cant find documentation anywhere on which valves are intake and which ones are exhaust. The FSM sheet above is what i’m working with I’ve been digging for an hour online. What am i missing?

See o-ring in pic here. Headed to Napa to see if i can source from shelf. Can’t find it mentioned anywhere.

Parts diargram doesn’t show an 0-ring where i circled in red on the parts diagram but my injectors have a small o-ring there. Anyone have any ideas on the part number for this o-ring?

Bump still looking.