Recent content by Edcantera

Hi there! Did you end up replacing the entire door card or cove it the armrest in leather or vinyl? The same thing has started to happen to mine.

The upper vents blow cold and the buttons seem to work as expected. I was thinking it’s an actuator issue but didn’t even think about pulling the heater fan fuse. Thank you for the tip! I’ll try it out and report back.

I searched and couldn’t find anything on this particular issue. When I run the rear AC I get heat from under the front seats even though both front and rear ac units are set to cool. It’s so bad that after a while of the rear AC being on the lower rear section of the center console gets really...

I’m hoping that Ben has a good relocation and that we are all able to get back in line for some of his awesome products. I sent him a few PMs before reading his latest post. Now just waiting patiently for a reply. 😁

I wanted to share a recent repair on my passenger seat. The shaft that transmits force from the motor to the far side rail failed. I think that something must have gotten wedged down there at some point and damaged it. The motor worked and the seat would only slide forward on one side. I was...

Bump. Anyone that has a reasonable offer send it over. Hoping to not have to part it out and scrap it

I’m not entirely sure how to approach pricing this out. Similar trucks are selling for 15-20k even when in rough shape cosmetically and higher mileage. I’m thinking that a 50%+ discount should cover the repairs/hassle of getting it fixed so I’m coming up with $8500 OBO.

I purchased a 2000 LC with a broken front diff with the intention of taking some parts off of it for myself and for sale and then scrapping it. It's seen better days inside and out, but thought it was worth a shot to try to get it running as is, especially since I had to be able to move it. The...

I am pretty sure that the lights worked but I'd have to check to be sure

If you are still looking for a volunteer I have a 99 LC100 with about 240k on it now. I manage an automotive repair shop and can install it myself and give you feedback on the installation process and operation of the unit. My wife drives it a lot more than I do hauling our kids here and there...

Hope it works out for you too!! Report back when you get it working.

I didn’t take pictures of the installation but I was able to install it using a couple of small flat head screwdrivers to get it out without breaking the cover trim. You have to apply pressure to the switch as you release the tabs in order for them not to lock back into place.

My mirror switch went out and after looking into the oem unit, and finding out it was $150+, I decided to look around for alternatives. I found that a 2008 GMC Canyon switch is nearly identical, has the same connector and the wiring diagram was the same/similar so I decided to give it a try. I...

Do you have a good rear view mirror? Mine is really weak at the pivot so it moves position if you hit a bump or every time I put up my sun visors.