Were the hoses damaged also? Some folks in another thread replaced their hose t's with brass t's. This is the item name on amazon for the brass t's: MettleAir 123-10-1 PK 5/8" ID Hose Barb Tee T Union Fitting Intersection/Split Brass
Here's the full oem part list for the hose t's plus all...
Cleaned MAF and dirty throttle body (before & after pics) on my new-to-me 2004 LC with 134k on the clock. Popped in an ebay'ed k&n filter after cleaning and lightly oiling. Installed SG2 and idling right about 700rpm once warmed up.
Throttle body was a little tricky to access since the intake...
Does anyone have pictures of the 80 series raingler net installed in their 100? Thinking about getting one but would like to see how it fits before pulling the trigger.
I had the same problem yesterday. I jiggled the wheel as I've done in the past on other vehicles but that didn't work. The steering wheel was completely locked and the key wouldn't turn. I ended up following the steps listed under how to unlock a locked steering wheel here and that worked like a...
I've been working with a Toyota dealer this week to get a reman trans installed under warranty. FWIW it is OEM Toyota and they said the trans itself costs them $2950 which is lower than they've seen in the past. Apparently other reman trans companies were charging more than that this week. Hope...
You could have a bad new sensor but Bosch should be fine as long as that part is considered a suitable alternative to OEM sensor. Check resistance on new sensor using the acceptable range in the FSM. The diagnostic FSM section has a few pages dedicated to this code. Check for voltage too in...
@2003lx470
Just saw some nice oil filter wrenches at my local hardware store that fit on a socket wrench so hardware store might be a good place to check if auto store isn't close. I'd think those socket style wrenches would be best. I've tried most of the other styles and don't use then anymore...
I saw there were others listed as similar to that ebay listing that look like the same part from Taiwan but at about $60. I think I'll have to pick one of these up also within the next couple months to see how they stack up to the OEM grill. If you pick one up, please add to this thread to give...
Ran across this on eBay the other day and thought the price was interesting since it is significantly lower than OEM grill:
http://www.ebay.com/itm/331414051754
I thought it was the OEM part at first but it turns out all parts sold by this seller are OEM copies made in Taiwan. Has anyone tried...
Thanks for the advice! I appreciate it. I'll do some searches to dig up other threads too. Will be sure to check the low spots (rocker panels, under spare, etc) carefully.
I'm a new member. I've browsed in the past but just signed up as I'm planning to buy a '03-05 LC in the near future. You have a great forum here.
I found a 2003 within a couple hours drive from me with 115k miles priced at $19,900. The exterior photos look good with no signs of damage or rust...