Recent content by EasternYeti

Great tip thank you

Did those front sway bar links come with the kit as well? Or did you have to ask? Checking my quote from them and I don’t see those on it Likely ordering a full kit this week since my OME’s are totally flat

You ain’t off the hook by any stretch - waiting on the LS fittings chief

We’re all low key waiting here with bated breath as we slowly die in the heat Setup a kickstarter and just use pictures of old condensers to troll us :hillbilly: @cruisermatt

Sold!

Confirmed, no spacers are necessary on these rims

So this will sound like sacrilege but I learned it from a buddy of mine doing it on his bmw. The biggest PITA is usually stretching the plastic over the butyl tape. It never goes where you want and it’s seldom as tight as you want. At any Home Depot or Lowe’s, they sell floor protectant the...

For inquiring minds, what did these springs set you back? Trying to ballpark what I’ll need to budget for a front and rear setup

Selling a set of 5 Tracker 8 rims w/ tires. Four are wrapped in 295' KO2's, one will be a standalone rim I used as my spare. I'll get a tread depth gauge and take some measurements this week, they're not perfect, with maybe 40k on them. two tires are useable but not great due to a bad tie rod...

Bump, these will be off the truck in a week in place of a new set of rims if anyone in the northeast is interested

Brother I saw this and have to chime in. I did everything you did so far chasing the water. Fender, cowl, grommet, windshield seal. As I rebuilt my doors I had to leave my truck outside, and as usual it rained. Only then did I see the water come down the outside of the glass, run under the...

This makes me feel better, I ordered the later slave and throwout for sure. I was beginning to wonder if I needed the older style bracket and spring to apply a little more pressure Assuming yours did the same then did eventually quiet down?

Putting this up here to try and see if anyone’s had a similar issue After 9 years the throwout bearing behind my vortec swap was tired and after a few hours of driving you’d hear a classic “type writer” tick when it was in neutral With a fingers worth of pressure on the pedal, it would stop...

We’re the Holleys plug and play? Curious how guys on here got around the reversed polarity on our trucks Getting tired of replacing H4 bulbs and I’m on my 3rd cracked light

Hey Jason are these going on your site or just a mud- ifyaknowyaknow type of thing? Look fantastic along with the new sway bars