Recent content by DMCTX

I had the same thing happen to me in DFW area last week in my 2006 LX470 with 306k miles. Hot day, traveling at 75 mph, traffic stopped and it started shaking and felt like a misfire. Gas pedal did nothing and I had to be pushed off the highway. Once the car cooled off, it started and ran fine...

I think I may have found the issue! Lol

I have a 2006 LX470 that has recently started showing some electrical gremlins. When I turn on the right turn signal, the reverse lights flash with the blinker. I unplugged the two tail light assemblies on the passenger side to see if that was the issue, but it was not. Then I noticed that the...

I did the same thing about two years ago. I was also able to disassemble the pump, clean it out, and bleed the system. Everything worked great after that.

FYI regarding firmware updates - I recently installed the Dec 2023 firmware for the CC3 and I was surprised to see that nothing really changed. However, I finally took the time to perform a factory reset and after that I am seeing improvements. Particularly, I am no longer having issues with the...

I believe it's 87106-60120

I just received my shipment today. (DFW area in TX)

Ordered!

+1

Thank you!

No I'm not sure, but the only major change I've made is to install this unit so I thought I'd check on this thread first.

Has anyone had issues with the heater working with the Teyes system? My A/C works fine, but now that we have cold weather in Texas I need some warmth. When I crank the temp to Hi, it just blows room temp air.

For those who have replaced the rearview camera, did you remove the original camera and mount the new one in that spot? If so, how did you mount it? Thanks

Thanks for the response - I was finally able to get it seated. I just kept working on it by pushing in with the steering knuckle and then grabbing the housing with both hands and pushing it towards the diff.

I’m installing aftermarket CV axles. These are temporary until I can reboot my OEM axles. The passenger side will not go any further than what is pictured below. There’s no lip to tap on, and I’ve attempted to push it in using the knuckle. Any suggestions for getting it in further or am I good...