Recent content by davegonz

Yeah, Partsouq shipping is always cheap, but I wonder what it cost for something that big?

Is there a Mudmember2020 discount code?

Cim, That inverter is all-in-one or do you have to connect it to an external inverter that take the 12VDC and converts it to 110AC?

Happy belated Birthday, Jimmy!

Vanity plates negates the poverty pack experience. 😀

Out

Good meeting you yesterday, Will. Let me know when you start the project.

Talk to Joe @joekatana about the 1HZ.

I'm probably going to be mountain biking there tomorrow after work. Maybe you can stop by and I'll let you drive it around.

Here's the top plate/manifold that I used: Cold Hose - Nippondenso 10PA Compressor Manifold Fitting with Short High Pressure Relief Valve - Denso 10PA17C 10PA20C Compressor Manifolds - Compressor Adapters - Specialty Fittings You will have to buy some right angle fittings and make your own...

I love the turbo'd 1HZ! What part of town are you? I'm in NW Austin (Anderson Mill/620).

Here's what I did on my 1HZ swap into my 60. The compressor (10PA15C clone) info is in the thread. I also used a top plate on the compressor that allowed me to use generic AC fittings. https://forum.ih8mud.com/threads/back-in-a-60-series-1hz-swap.1026075/page-17#post-11891292

Naah, AJ gave me the rubber pad that fixed that. My 60 is a mess under the dash from the PO's stereo installations.

Looks great, Cim. Now come over and clean up my wiring!

That cluster look sharp! Nice color scheme selection for the Speedhut gauges.