Recent content by Dannyboy96

  1. Dannyboy96

    1998 - 2007 Toyota Land Cruiser Factory Repair Manuals

    is there a version of this for GCC spec 1fz Engines 2006 models?
  2. Dannyboy96

    1FZ-FE Stock VS Light Head Mods Dyno Numbers (+62 lb-ft)

    May i know which shop here in qatar did you have your head ported and polished?
  3. Dannyboy96

    1FZ-FE Stock VS Light Head Mods Dyno Numbers (+62 lb-ft)

    I'm based in qatar also, did it have any noticeable sound or any rough idle after the mod? I would like to do this but also maintaim the daily driveability and reliability of my 100 series
  4. Dannyboy96

    Body panel under headlights?

    I'm looking for the same, hoping someone can provide the part number
  5. Dannyboy96

    Loose connector in ECU Question

    Hi good day! 1st time removing my my dash compartment to check my ecu and saw this loose connector, any idea which wiring or sensor is this connected to? I have an FZJ100 GCC on 1fz-fe engine
  6. Dannyboy96

    Center Differential Lock Transfer Indicator Switch Problem

    I had the same issue, cdl most of the time works but during few minutes of riding on dirt roads with the cdl on, when i suddenly turn it off it won't open again for a couple minutes even if i switch it to low gear, i replaced already all the sensors on the transfer case but still usually it...
  7. Dannyboy96

    The OFFICIAL clunk/thunk driveshaft thread

    I have an FZJ100 2006 GCC Spec Land cruiser full time 4wd running on 1fz fe engine. I have also the RND clunk which you have mentioned but i don't think about this seriously given the car's age and there's no issues about it running. My main concern is i'm hearing some knocking down below...
Back
Top Bottom