Recent content by DanjenG60

After having the vehicle at both a Lexus and Toyota dealership, and both stating the vehicle had no issues, I ultimately replaced the steering rack again. I guess I got a bad unit from rock auto. With the new one, no more issues. Haven’t checked to see if the stored codes have cleared or not

Used a cerakote kit on my old, foggy headlights. Pretty happy with how it turned out.

After the never ending issue, I purchased a cardone steering rack, supposed to be a reman oem rack. Got it installed, no more issues. Happy to not be chasing my tail any longer

I highly doubt it’s due to water intrusion, I never had a single issue with the vehicle until the new steering was installed 2 months ago. I can get the vsc to kick on during driving on specific roads and off ramps, every time. It’s when the car has some body roll and is turning. Hence a yaw...

When I do the signal check this is what I’m getting

Steering rack is centered. The tech at Lexus drove the car, turned the wheel all the way to the left, back to center, then to the right. Same amount both ways. I have had the car aligned twice, both within factory spec…. There are no active dtc, but I can pull the stored codes and they all...

Unsure if the 460 and 470 are identical regarding this issue. There are no active codes when connecting to techstream. I have no lights on the dash when starting and driving the car. The vsc issues happens randomly when cornering and if I let the car roll backwards on an incline. I’ve done the...

someone has to have some insight on why my 2004 gx470, simply will not take a zero point calibration. I started a thread on this issue a few months ago with no avail, frustrating as I’m sure I’m not the only one who’s had this issue. Super long story short, had a new reman rack installed and now...

Still no prevail in getting this lined out. Added new brakes on the front as I was getting some dive upon breaking. Steering rack is still reading 1150 upon start up. Thinking that has something to do with the zero point calibration not working. I do have the fuses under the hood pulled for the...

Installed new power stop gx460 calipers, pads, and rotors today. I was getting a hard dive under breaking and it solved my issue! Still having random vsc issues under cornering after my steering rack install. I’ve done a ZPC a million times with techstream and still having the issues. If anyone...

If anyone is using their techstream in the next few days, could you please run your live data at start up and report back what your steering angle reads before driving? I’m having some issues after a new steering rack install. Mine will show 1150 upon start up, then will zero out after driving...

Slight update, I tried doing the paper clip method on the ZPC and am still having the same issue. No lights on dash but the vsc is still engaging when turning, for instance when taking a turn on a long on/off ramp. I did notice when looking at the live data that the steering angle is always at...

I’ve done the ZPC numerous times and am still getting the 1150 steering angle upon startup. After I drive a short distance it will then show zero. I don’t feel like this is normal? Anyone else have any experience with this? I keep doing the ZPC, on a flat surface, then drive straight until I...

Thanks for the update. Have you happened to see what the steering angle is upon start up, before driving, after doing this? After doing the ZPC mine was still showing the 1150 until I would drive the vehicle. After a short distance it would then read 0 or whatever corresponding angle the wheel...

So I was able to upgrade my techstream to version 18, still not able to access the VGRS on the vehicle. I’ve read where it can be related to the cable. Not sure on that end, any users on here able to access the VGRS system using the mini j2534 cable? Thanks