Recent content by cruiserland

I can cut one off for ya

I could come up with a set

Heh...it's not that different than fixing rust! But man my back does hurt... Ya i had a 200 yr old house for 20 years...hand- dug , wheelbarrowed out, bout 70 yrs worth of porcupine s*** out of 5 foot dirt basement...literally four feet deep. That was less fun...took a couple weeks. Was stacked...

I will get pix..didn't make it to shop today, fixing some house issues...

Have in NH

I have a couple, will get some pix

I have both, I'll get pix tomorrow

Heres one off a 73..surface rust but solid. In NH

I don't have any..there's a couple yards in Texas with low mileage wrecks..400 each side, call em and see if they'll ship carparts.com

Have this, no cracks

Pretty sureI have in NH,will check tomorrow

Next to pass side, different angle

Same

Well that's a top left I've shown The top of the swinging part is deeper to account for door angle...keeps hinge pin vertical I'll get a better shot next to installed unit in a minute..