I have a Tundra and a LC both have different uses. I also run two businesses so I use the Tundra to pickup supplies every week. It would be more difficult with the LC. My wife drive the land cruiser as her daily and its a better kid hauler than the truck.
I have a 2020 LC and use ECT power but I really dont feel a difference in driving. I guess its similar to Tow/Haul, which I use in my Tundra and turns it into beast mode.
The bolts are installed underneath your LC on each side, look under and you should see them. Unscrew them and use the same bolts to install the OEM boards
Any recommendations on shops in the NOVA area (Fairfax, Chantilly, Centreville, Sterling) that can install the leveling spacer (fronts) for the LC200? Also need to install my cat shield for my Tundra but I need two notches cut on the 10ga steel to fit under my TRD Pro skid plate.
I paid around that for my 2020 HE with 20k miles and I have no buyers remorse whatsoever. Go for the 2020 with 25k miles, you can also purchase a nicely priced extended warranty from a few dealers mentioned on this forum. I'd do it, you only live once and you know for sure that it'll hold its...
I actually have the wind fairing, for some reason the previous owner had it tilted downwards. It was very loud at that position but once I put it vertically the wind noise was reduced significantly.
Thanks guys, I bought it for $98500 OTD, one owner with 19950 miles. I know I overpaid but I've been wanting the LC for a while so I'm happy.
I've posted a wanted ad in the classified section for the OEM running boards, if there's not hits then I might go the Budbuilt sliders.
The current...
Hello,
I am looking for driver and passenger OEM running boards with all the hardware for my Land Cruiser HE. I'm located in Northern Va, thanks for looking.
Aaron
New LC200 Heritage owner here. Not the greatest dealings with the Toyota dealer but its finally here. Things planned for the LC:
1. Add running boards, this thing is not going off road and it will be a mall crawler for the wife. I'm thinking about just going with the OEM running boards, is...