Recent content by clumbers

Yepp, I typed in my vin to partsouq, and it came out with the following part number: 95331-06012. Nonetheless, I’ll grab this and give it a shot. Thank you.

@Kernal getting some conflicting info on the throttle body fuel hose...Some forum members mention following PN 95337-06020. However checking fitment on toyota parts deal.com says does not fit and recommends 77213-60090. Further, Partsouq says 95331-06012 but when clicking nothing comes up...So...

Understood, it was at CruiserTeq in SoCal, which focuses specifically on Land Cruisers.

Good stuff, thank you. Luckily, I had my mechanic replace the heater hoses, so I’m good there. The other stuff I’ll add to the list.

1FZE. Thank you! Exactly what I was looking for.

Hi all, Looking to do a little PM and clean my TB in the coming weeks. Planning to replace the hoses as well. I found the gasket and IAC o-ring but I can't for the life of me find all the necessary hose PN. Does anybody know them?

Thanks all. Found a good friend who is willing to show me how to MIG weld, so two birds, one stone with this install. On those sway bar brackets, assume will need to drill holes there? @Outsane

Got it. So for light / moderate trails, you’d recommend new OEM end links to those extensions as the simplest option?

Definitely have a drill and no plans to do any extreme rock crawling in this in the near future. I think I’ll give the riv nuts a go. Wish me luck! Recommendations on what length to set the end links to? Hoping comes with a manual - haven’t been able to find a Mud post on installation but maybe...

After a bit of investigation, it appears I have the factory end link on an extension link installed currently. I note Baldilocks statement above…So the question is 1) Do I even need extended links? What benefit would it add? 2) If so, do I still need Rivnuts or can I use the extension link? 3)...

Assuming the links come with an instruction manual? New to the whole DIY thing and would like to give it a go solo before throwing in the towel and paying someone to do it.

Great, thank you. Have you got the sway bar disconnect too? If so, how's that working out? Does it work for rear or front only?

1994 US model

Do I need the rivet nuts as well?

Thank you both!