Yes you are correct the atlas will put the driveshaft at a slight angle. I'm interested in the possibility of upgrading to a different rear axle in the future. This is my fishing rig and I don't expect to daily drive it. We'll see :) I will have to make a new main tank because the center output...
Nice! That's pretty reasonable.
I've been looking for a checklist for the fj80 ls swap?.. Part numbers and such? I've got a handful of items sorted out but I'm sure there's something I'm missing. Does anyone in here know of any such genaral checklist that pertains to the fj80 ls swap?
I know...
A buddy and I I've got a Badlands 12000 on a car hauler trailer. so far it's great. It's helped us get a few vehicles on the trailer and it's affordable. I would consider one on a Land cruiser because it's not something I would see myself using everyday but then again this is something that if...
No doesn't work with an atlas.
I don't need the expensive adapter my 80 will have the 4L60 mated directly to the atlas. Then I will do a part time conversion on the front end.
After the cost of a part time kit, an underdrive gear set for the HF2A, and the 4L60 to hf2a.
I could just buy an Atlas...
I think all the newer housings are. I'm losing the HF2A and ordering an atlas with a 3.8 low range and building a custom 2 tank setup at the same time. The center output of the atlas interferes with the front corner of the main gas tank.
The kit includes a shaft and housing and everything that adapts the 4L60 to your transfer case. You need to order the correct marks adapter if you have an 80 there's a great chance you have a HF2A if I recall correctly.
I'm currently working towards a 5.3/4L60/Atlas swap.
I'd like to hear some of the things you'd do differently if you were to do another swap.
Different parts? From who?
What didn't work?
Thank you for your knowledge!
I am interested in getting a 2speed atlas but the output for the rear DS comes out following the input shaft. Which I'm told interferes with the front inside corner of the stock gas tank. I need more parts before I can make the determination for myself.
I've done quite a bit of searching through the forum but I haven't been able to find what I'm looking for.. I'm hoping someone might have a part number for a gas tank for my 93 fzj80 that would allow for the use of an Atlas transfer case behind a 4L60?