Recent content by Claytonk

Yes , it has 2 belts. I was just trying to verify that it should be a 17 mm , all the parts stores were trying to sell me a 15 mm x 1803mm, which may work also? I will try to find a 17mm x 1803mm. If that belt exists?

I guess what I'm getting at does anyone know if the original belts from the factory were 15 mm or 17 mm in width? The belt I took off matches up to 15mm but from what little bit I found 17mm seems to be the correct part from the factory?

Cruiser matt also has a three belt Toyota kit and I noticed two are cogged and one is smooth I'm not which ones are supposed to be smooth or cogged?

Trying to source a new belt for an 82 fj60 with aftermarket air conditioning, I removed the belt and measured it and it measures 71 3/4 " on the outside diameter. The truck has an aftermarket York AC system. The belt routes around the crank pulley power steering pulley alternator then the AC...

Went to change the thermostat on my 82 FJ60 , and the upper gasket I purchased from Toyota was a lot smaller than the gasket I pulled out of the thermostat housing I was just wondering if this is normal do they swell over time? The old one fit perfectly in the indention of the upper thermostat...

Kept on forgetting to post this but yes I think solenoid is missing

yes it has a/c ( not really functioning ) yes it has the York compressor It seems to be missing the solenoid or never had it Its my understanding that some early 60's where ordered without a/c and then were dealer or port installed with the York system when they came off the boat.

https://forum.ih8mud.com/threads/87-fj60-a-c-vacuum-actuator.498407/ Okay so I found this post after you guys pointed me in the right direction of what this thing might actually do. indeed it's the AC idle up vacuum actuator

New to me 82 fj60

31x10.50x15 pirelli scorpions Stock wheels and suspension

So I think your saying right around here somewhere but I just don't see it?

I'll check it out tomorrow

Hmm? I'll have to check by the compressor to see if I notice any vacuum lines that are missing

I searched through the emissions manual but cannot find this part? can anyone help identify it and tell me where the hose that's supposed to be on it goes?

My lenses are actually ok so I could reuse them, it's the sockets that were trashed. I guess the seal was bad. Are the seals replaceable/available? Are the sockets replacable? It didn't seem that they were. When I took it apart it seemed to have some sort of plastic film that had almost...