Recent content by Chiro6262

  1. Chiro6262

    Wanted Fj40 transfer case near seattle

    I'm looking into the issue. It's a 350 conversion. The previous owner forgot a spacer which resulted in damage. The transfer that's in it may not have been original.....
  2. Chiro6262

    Wanted Fj40 transfer case near seattle

    Looking for one to fit in my 79 FJ40. I have one from a 70 and a 78 but the shop doesn't think they'll work. :(
  3. Chiro6262

    Wanted Fj40 transfer case near seattle

    Looking for a good transfer case located in Washington. Do you have a parts rig with one available? Please contact me.
  4. Chiro6262

    Where does the red SOLENOID POWER wire connect to? Using EZ Harness

    Wondering if you finally got this figured out? (I hope so it's an old thread) I have the same Not so EZ wiring harness and I don't seem to have the faded purplish wire labeled "IGN SW IGN wire" you show attached to the ignition. Where does that wire run to? Fusebox? Where does it go after that?
  5. Chiro6262

    Starter wiring help

    Looks like the engine turns. I removed the starter and battery tested it. Solenoid pops out but the starter doesn't turn. I broke down and bought another wiring harness for it and now need a starter. Hopefully I can rewire this thing and get it on the road.
  6. Chiro6262

    Starter wiring help

    Yes the solenoid clunked like it was popping out but the starter was not turning over. Nor did it try. Although it did briefly turn the motor then stopped.
  7. Chiro6262

    Starter wiring help

    I like jacking up the back wheel technique. It's a bit hard to get to the crankshaft pulley. I'll see what happens.......
  8. Chiro6262

    Starter wiring help

    It did crank somewhat slowly for a while then just stopped. The coil+ to battery connection was referenced in another thread. I gotta get back in there and make sure the engine didn't seize. ;(
  9. Chiro6262

    Starter wiring help

    I believe the engine/tranny/ starter are out of a 78. I attempted to swap the old 70 starter but it just grinds. I'm thinking the 78 starter may be bad?
  10. Chiro6262

    Starter wiring help

    I believe the engine/tranny/ starter are out of a 78. I attempted to swap the old 70 starter but it just grinds. I'm thinking the 78 starter may be bad?
  11. Chiro6262

    Starter wiring help

    The black/white wire runs from ignition (ig) and the black/yellow runs to ignition (st). Coil negative runs to distributor. Coil positive runs to battery. Coil positive also has a wire to tac.
  12. Chiro6262

    Starter wiring help

    This is a 1970 and it has not been started since engine install. But the wiring is a rats nest. Is there an affordable wiring harness available? I will load a few pix this weekend of the alternator/battery/coil. Thanks for the help.
  13. Chiro6262

    Starter wiring help

    Looks like the fat white wire runs to the amp gauge.
  14. Chiro6262

    Starter wiring help

    So I may have gotten a bit over my head swapping a motor for my son's FJ40. The PO said this would all be an easy swap. I can't for the life of me figure out where these wires all go (are they hooked up right?). The Black with yellow stripe is disconnected and just hanging there.... Don't know...
  15. Chiro6262

    Electric Fuel Pump or oil filter relocation?

    One like this that has the inlet at a slight angle? I wish I could be sure of the year on this motor (I'm just trusting what the PO said it was).
Back
Top Bottom