Recent content by CharlesHS

I believe the difference between the 60180 and the 60190 is that the factory brackets need to be reused on the 60180. Correct me if I am wrong.

Beno, Thank you for the heads up that the above suggestion would not work. Any thoughts on a source for a custom condenser or aftermarket solution ? Charles

Do any of the US located LC vendors have access to an after market condenser that will work on my 1993 PZJ75 ? For comparison the factory Toyota DIY PN is: 88460-60190. ? I am in Florida and Appreciate any assistance. You can contact me at: cstein51@gmail.com

UPDATE: The speed controller arrived at my FL address and that part along with a new set of Rigid 4” amber LED lights will be in my luggage along with a few other items.

The Intermittent Wiper speeds 1,2 & 3 were not working, but speed 4 works fine. This problem previously occurred, but the function returned a few weeks later. I have tested continuity thru the wiper speed selector on the steering column and it works fine. Using the Factory Service Manual...

UPDATE: The technician was able to fix the leaks in the condenser tubing, replaced the accumulator/drier, replaced a leaking low pressure line, replaced the TXV, installed a HPCO and chemically flushed the entire system. In the eight years I have owned the truck; the A/C system temperature has...

IF the technician cannot locate or repair the condenser; I will have him seal the system hoses and I will try to locate a replacement drier once I am back in the US. I plan to return to the PI in January which will give me time to also locate a replacement condenser.

My PZJ75 has the older style V belt driven components. The compressor has a dedicated single V belt and the other components are driven by 2 V belts. The A/C system is R134A and the new compressor has a V belt clutch. The numbers on the old compressor match what the new compressor has on it...

This morning after replacing the compressor and flushing the system I discovered the condenser on my 1993 LC PZJ75 has a leak. I have a technician attempting to repair the leak, but I decided to research the PN on ToyoDIY. The PN I found on ToyoDIY is: 88460-60190 Searched on Amayama, JP...

Finally back in the Philippines after being gone for almost 6 months. Previously I replaced the flex hose and clutch slave cylinder on my 1993 PZJ75 and even after flushing/bleeding the system about 30 minutes later the hydraulic clutch would be spongy. I determined that original OEM Master...

https://www.toyodiy.com/parts/ You can look up the PN using your Chassis number.

Good question. Its indicated on the tag of the clutch. Confirmed Denso 447300-1520 is 12V 1A

This is not a What did I do to my LC, but a What did I do for my LC. Today I ordered a complete compressor assembly (compressor, clutch and pulley) for my PZJ75 from JDM Restoration of Australia & Japan. The compressors from Amayama, PartsOUQ and a few others only sell the compressor; the clutch...

Enjoyed the story...

YES... That is the one... When I tested mine I also addressed the BQ connector just inside the cab to ensure the voltage was at that point; which there was...