Recent content by Carzan

Hey all, I have an update. I ended up getting the TYC 1918 rad and the one they sent me had a few flaws, and I ended up sending it back and getting a replacement of the same rad. But I had a question for you guys. I noticed the bungs for the oil lines in the bottom of the rad had some thread...

Do you know the part number for the TYC one?

The OEM radiator finally s*** the bed today, so I need to get a new one. Has anyone used the CSF 2517? As of right now, that is the one I am looking at getting. I have a 93 80 series with the 1FZ.

The drain plug threads are stripped

Is there a Toyota RTV I can use lol ;)

I had to order a new lower oil pan for my 93 FZJ because the threads on the current oil pan are stripped. I looked but could not find a gasket for the lower section of the oil pan. Does anyone make one or should I just use some RTV?

Here are some pictures of the lines I believe are leaking

I believe it is leaking from the hard lines that go over the cat. Are those the ones that go to the rear heaters?

My 80 has a pretty bad coolant leak but I can’t seem to figure out where it’s coming from. It is dripping right at the catalytic converter. Here is a picture of it Do you guys have any idea where it could be coming from?

Hey yall, I have been collecting parts for the quad headlight conversion, but I had one question that hopefully someone can answer. Does anyone know if there is an aftermarket or OEM part for the headlight bucket? I heard you can use 84-85 camry headlight buckets, but there has to be others that...

Both are connected. I think that maybe one of the sensors is bad. Is code 52 only the front sensor or both sensors?

A couple of weeks ago, I finished my head gasket on my 1FZ-FE and everything is running great! Except for the knock sensor check engine light. We replaced the sensor before we re-assembled the engine, so we thought it was the connector. We ended up getting a new connector and replacing it, but...

That was what I was looking for! Thanks!

In your picture, I can see it is the one that has no hose attached. On the left side of the photo right by the 90° bend

I took the intake back off and there is no metal line anywhere near that hose. I’m thinking it might be this one here