Recent content by Birk

https://kansas-city.certifiedtransmission.com/services/clutch/flywheel/ Did you try Certified Transmission? They have a location in Blue Springs.

Count me in for 1.

Great looking camper!!! FYI-I just pulled a tank from an 86 PU, the fuel/varnish was easily removed but there was a lot of rust in the bottom. I ended up replacing the tank to make sure none of the solids caused problems later. You might be able to inspect it with a camera from the fill tube...

We just replaced rear springs on a taco, used a 4" angle grinder with a cutting wheel, made quick work of it. Had to cut the pins and u-bolts!!! Pry the frame away from the spring to provide room on the inside for the cutting wheel.

Yes I am interested. Could you send a few more pics?

https://www.generalspringkc.com/1984-1988-toyota-4runner-rear-leaf-spring-4-3-1-leaves/ I installed these on my 86' 18 months ago and they are working great. Original stance and are holding up fantastic.

I will be there, put me down for 1.

See you guys there, in the 4Runner. Almost have the 40 on the road, but definitely not road worthy yet.

Looks like I am going to be able to make it this month, I am excited to catch up and experience a new coffee shop

Where did you source the SR5 Cluster?

I am looking forward to meeting more great people in the club, put me down for one.

Sold Up for sale 68/69 FJ40, will turn over but it is not getting spark. It was used as a trail vehicle previously and does not have a title. Asking $2,500.

Sold

My 72 looks similar in color to yours, but just reversed, with orange behind the red. I thought my original color was freeborn red, but I think now the original was orange? What year is yours?

I have just completed a carb rebuild and found that same weight and ball were missing. It ran good for the previous owner, so I put it back together and runs better now. I just need to adjust the carb to slow the idle. I do not have any backfiring issue at idle or underload without the weight...