Recent content by bfosterelli

Apologies if my searching is lame - I cannot find previous posts of any 300 series electrical wiring diagrams for my '23 LX600. Anyone find one out there yet? Specifically, I'm looking for the automatic engine start/stop circuit. Thanks in advance!

I have officially followed every procedure I could find in the FSM. I must be missing something in the process. Going to start over and pray!

@Fj80oregon what general area in Oregon are you in?

Subscribing, my head is back from the shop, complete valve job/rebuild. About to pull the block out and do all seals, timing, and hone or potentially have shop bore & deck.

I completely removed the VGRS ECU for almost a full day, hoping by not picking up any residual voltage it would reset...no dice. I think it needs the same reset as I found with the LX470/100 Series (applying + and - from battery to certain pins), but like I mentioned, the pinouts don't match for...

Thanks, yes. I think my problem is that the codes won't clear, with my scan tools and with Techstream. And when I get lucky enough to clear, they immediately trip during the recalibration process. Almost like there's a trick for the ECU to not trip on the missing calibration from installing the...

I have searched high and low, downloaded all sorts of instructions and printouts, used jumper wires on OBD, used Techstream, etc. but cannot get my VGRS and ZPC done. 2016 Land Cruiser I was rewrapping the leather on the steering wheel and snagged the cable to the clock spring. Therefore, I've...

Old thread but I was doing some searching and came upon it. FYI, Harbor Freight has a Large Valve Spring Compressor that appears identical to the OTC model. HF number 58802, $59.99 as of today. I'm going to get one to see if it works.

Old thread but my ARB bumper is less than two years old, wired as marker lamps, just noticed both lenses have melted and deformed, bulbs ARB supplied.

For those who haven't owned modern European vehicles w/ rear fog lights, I can tell you I've owned vehicles with one side illuminated, and both sides illuminated, depending on the year and manufacturer (all 2017+). For anyone who lives somewhere with frequent or occasional dense fog, this safety...

Same manufacturer, identical part when I removed the old ones, AISIN made the OEM actuators for my rig.

Amazon has the same P/N (AISIN)...but they also have cheap ones - so shoppers need to look for the correct item if they're wanting OEM-quality.

I ordered them. We had similar ones on our '18 LX570 and loved them. I'll be dropping the headliner and fabricating or 3D printing whatever mounting & reinforcements I need. Fingers crossed the length & width are suitable. If not, I'll resell 'em. I will report back, and will also capture...

Listing says '98 - '02, and the specific vehicle they came from was 2002.

I bought the AISIN ones off Amazon for both rear doors, 100% OEM fit and function, working awesome (and not too expensive @ ~$45 each). LH Rear: https://www.amazon.com/gp/product/B01M16FGBE/?tag=ihco-20 RH Rear: https://www.amazon.com/gp/product/B01LXA2HB3/?tag=ihco-20