Recent content by Beanzermin

Did front and rear brakes today. Honestly after 9 years I’m shocked how the POR15 caliper paint has held up. Might be time to redo them though. They are chipping and definitely aren’t shiny any more.

I tried that a couple times. Even sprayed simple green on them and let them kind of soak first. But it never was enough.

My seatbelts are disgusting and hard as a rock. I’ve tried to clean them with no luck. I sent them to safety restore. Instead of tan, I picked out a brown, which I hoped would be close to the tops of the door panel and dashboard. They are much more “bright” brown then I originally thought it...

I noticed just recently I haven’t heard my A/C fan kick on… peaked up at the relay and noticed I have a broken wire. So I ordered everything to replace the wires, connector, and relay. Once I tore it apart, it was only the one broken wire. All the terminals still looked clean in the connector...

They also had a good center console lid. So I replaced that as well. Tore my center console lid apart and started to rewrap with new leather from Land Cruiser Heaven.

Drivers door check strap has been clicking and making noise. While I had the door panel off I went ahead and replaced that too. They had a center console cupholder but theirs was broken and missing pieces. I bought it and was able to put the 2 (my original and theirs) together and make 1 good...

on one of my adventures I was rushing to catch back up with the group after taking some pictures. I jumped in my truck and didn’t realize my camera had fallen between the seat and the drivers front door. When I closed the door the lens got caught in between the seat and door pocket and ripped my...

So after reading this thread a lot of people are man handling their rails to get the cupholder out. These are already easily broken. There is a tab that keeps the cupholder on the slides. If you insert a pick, a seal removal spoon, or tiny flat head you can push those tabs in and the cup holder...

Upgraded the big 3 ground wires with ones made by @Fourrunner. Shipping was fast! Craftsmanship is top notch! Thank you sir!! Also found some better brackets at the junkyard for my passenger engine harness. These came off the alternator on a Sienna. Grabbed a couple 15mm clamps and harness is...

got to the hardware store this morning. Was hoping to get some yellow zinc M6-1.0 hardware for the engine bay. Get rid of the stainless that I installed with the dress up kits. But they didn’t have any. So I got black oxide instead. We don’t get a lot of rust in the desert so I’m hoping these...

I ordered microphone mounts and a cup holder bracket from him in September 2025. Nothing on the site at that time was warning customers of the long wait. I have attached the conversations in the pictures. I got 2 of the 3 parts around Thanksgiving (almost 3 months after the order was place)...

For the longest time I have had a broken Lower 1/2 of the intake box. 2 of the 4 clips had snapped off. Both were on the same side of the box. Man-a-Fre (a Land Cruiser specialty shop) is local in Vegas and I have never been there before. So I swung by and they were able to source me a used...

Anyone know the part number for these harness clips?

I’ve had this rattle coming from my exhaust for a couple months. It’s gotten worse and is driving me nuts! The old heat shields on my drivers catalytic converter were all broken. Ordered new ones and new hardware! Finally that annoying rattle is gone! Tackled the power steering lines and...

Adding this list for future reference!