Recent content by alane24

  1. alane24

    Help with hose leak identification

    That rubber hose was very dry. I couldn’t see it, but I’m guessing there was a small crack around the clamp which created a slow leak
  2. alane24

    Help with hose leak identification

    Fluid didn’t really have a color, oddly, but I ended up determining it was a small section of power steering return line. Removed and replaced with a 12” section of 3/8” transmission fluid hose and a couple 3/8” fuel line clamps. Lost about 1/2 quart of fluid during the hose swap. For anyone...
  3. alane24

    Help with hose leak identification

    I think I have narrowed it down to a small section of power steering hose.
  4. alane24

    Help with hose leak identification

    View from the engine bay looking down
  5. alane24

    Help with hose leak identification

    Need help identifying this hose and what’s leaking from this hose. It’s visible through the round window of the skid plate.
  6. alane24

    Recs for MN windshield installer

    Good call!
  7. alane24

    Recs for MN windshield installer

    Appreciate the comments. I had the pleasure (?) of installing one trim/moulding piece and discovered that the original A pillar hole diameters were a bit larger than the OEM replacement rivets. That was fun. Had to go with the next size up and they held. Anytime it rains I’m just looking for...
  8. alane24

    Recs for MN windshield installer

    In need of a new windshield on my 03 100-series. I’m located in a suburb of Minneapolis and looking for a local recommendation for a skilled installer who will do the job right. Willing to drive for the right one.
  9. alane24

    Water dripping into US driver's side kick panel

    Never let a good thread die. Anyways, I don't know if removing the entire windshield is the first line of action. My truck has zero rust and has lived its entire life in So Cal. I know there are surprises, but I can guarantee it doesn't have rust issues. I replaced the passenger side riveted...
  10. alane24

    Another Leak Question (I searched first)

    I woke up to a small amount of water on the driver's side foot rest and noticed some droplets up in the electronics around the driver's side kick panel. Trying to pinpoint what is causing this. I think it's either a bad moulding (i.e. leaking through the rivet holes) or sunroof related.
  11. alane24

    Another Leak Question (I searched first)

    Keep in mind though that there are 4 holes that the outer windshield moulding is riveted to. Those can also leak, and that's a lot harder to identify w/o removing the moulding. I haven't tested for a leak there so your soapy water trick my also reveal bubbles, but I doubt it since you'd have to...
  12. alane24

    Water dripping into US driver's side kick panel

    Just discovered the same issue this morning after a long rain. Curious where you are applying the flow able sealant. Is it along the outside windshield weather stripping?
  13. alane24

    Parting Out I NEED A 7 BLADE TRAILER HARNESS FOR 2003-06 LAND CRUISER or LX470

    Looking for the following... Toyota PN 82177-60010
  14. alane24

    Wanted 03 LC Trailer Wiring Harness (P/N 82177-60010)

    Located in Minnesota and looking for a replacement. Photo is for reference
  15. alane24

    7 Way Trailer Wiring Harness DIY

    I was thinking about just eliminating the plug-in connector that is currently on the truck and hardwiring in a new 7-blade using the wiring diagram from this thread. It doesn't seem like any of these parts are going to show up.
Back
Top Bottom