Recent content by AdventureBound

I lived all over town in apartments, but was last over by the Taco Bell on 6th for a few years before moving to the KC area. Pretty sure we've bumped into each other in the cycling crowd over the years, long before I acquired my 100 series.

I probably won't be able to make it. I'll be teaching that morning at MOORE Expo. Should it rain out, I'll be there on either rainout date. Would it be possible to get the rundown of what is said later on? Thanks!

2nd on Adventure Motors for this. Had them do it to my rig and it was well worth it for the frame cleanup and coating. I believe they cleaned up the frame and treated bare spots with POR15. I need to make it an annual thing before the salt hits the roads.

I've not really been too involved with the TAC group other than a handful of events/meetups, and have also neglected to use this site in a few years (thanks to a previous job blocking the site...I guess they wanted me to actually work rather than Cruiser stuff haha). My name is Lucas and I have...

Just rolled over 229,000

Thank you!

Anyone know what the size bolt is used on the grab handles for the A-pillar? Thinking of adding a RAM ball to it to mount my phone on. Thanks in advance!!

Is this the plug on the outside of the frame rails?

If you wouldn’t mind grabbing some photos of that, I’d greatly appreciate it! I’m hoping to make the install seamless and not have wires running all over the place.

I am looking for a good spot to pass wiring through the trans tunnel or near it for a yellow box calibration harness. I cannot seem to locate from the underside and I have yet to pull around the center console to find it since the yellow box is still in transit. If anyone can provide a good...

Would the 70-8113 work for a 99? My aftermarket HU has an illumination/dim wire and I’d like to utilize that if possible. Thanks in advance!

I have a ‘99 so that may be the case. Thank you! This is all pretty new to me since this is my first LC

Thank you! I had to look a little harder at the pics for the 8116 to see it was two separate pieces. Thanks again!

thank you for the suggestion of the bypass harness!

Is this metra 70-8116 plug n play? I’m a little confused on what to do when installing an aftermarket head unit since the metra 70-8112 is also recommended. Would I need both harnesses, one to wire to the harness on the head unit and the other to bypass the amp? Any help is welcomed! Thanks!