Recent content by adistler1

Having a 20 month old will do that to ya! 😂

I’m going to be getting my seat frame, roll bar, tire carrier and emblems laid out and holes drilled tomorrow. Does anyone have measurements on those things? It’s been so long since my truck was together!

Was able to get back up to KY and get a little more done to my truck.

I got it fixed. I’m not sure why we had it sticking out that far, but it was a simple matter of taking out some sheets cruise, cutting one well, then sliding it forward. I bolted in and everything is sitting where it needs to now. As for the quarter panels wrapping around on the channel, if I...

What am I doing wrong here? The cover is sticking out quite a bit further than I think it's supposed to.

Can anyone tell me what's going on with how my sill is fitting? The cover is sticking out quite a bit.

You’d have to at least cut out the bottom portion of your quarter panels to get it in.

Harry got his body painted and put back on the frame!

It's been a minute. I ordered all my panels from CCOT, my sill from @Awl_TEQ and a few misc. things from Real Steel Cruisers. First off, the sill and the panels from CCOT are such great quality. I'm so glad I spent the extra money on going with them. As most know, life gets in the way. After...

When asked if it was a Ford, he said, "hell no chevy!" Here's a picture of the motor in question and speaking of never being able to experience the full output of an engine, check out the airboat he built from scratch. You could hear it coming from a mile away. The thing is incredible.

I have older doors on a 78 and am getting ready to build a new tub. I'm hopeful that I can use them.

Thanks guys. This really helps a lot! I was looking for the measurement between the actual pillars. Unfortunately I wasn’t by my truck and didn’t really have time to get a picture and mark what I needed, so sorry if there was any confusion but you guys answered it perfectly.

Hello all! I'm in the process of rebuilding my tub and unfortunately do to an awful PO, I don't have much to go off of. What little left of the original is completely rusted through and he got creative with zinc plates and pop rivets. I don't think my tub is at all where it needs to be for me to...

I need to support my tub but I think the width at the back is off to begin with. I have pretty big gaps when I mount the doors. Does anyone know the distance between the channel the quarter panels mount to? I need to get that right before I weld in my supports.