Finally picked this up from the laser cutter yesterday! Very excited, the cuts came out beautifully with almost no slag.
A quick test fit on the spare transmission case and everything lines up great so far. Only the clearance holes are laser...
Made some really good progress on the rear speaker enclosures this weekend.
I dislike paint work. I'm pretty patient, but painting is a skill that requires some talent too. I'm lacking in the skill department. 😆
They look alright. I'll have...
LS power steering STAINLESS STEEL pump adapters. These are extended to clear the pulley (WITHOUT REMOVAL) and allow for a simple 6AN fitting to be installed.
Jason
TT
Made a little housing/bracket/mounting thingamawidget for the rear camera.
Turned out alright. I dig it.
As always should've done some things differently, but nothing worthy of garbage can.
No cnc action on this. I didn't have the patience...
Just stuck the rear camera onto the back with magnets above the ambulance door and snuck it over the seal by the latch.
I think that's a good as is going to get. I made a little section with two plugs to spice into the harness I made for the...
Chassis is stripped down, fully welded out and ready to go to powder.
Motor is in the customs shop and should get started on tearing it down late next week.
Pete and his helper Damion are cranking on the cab.
@Butt Ugly Chuck came by with...
Welp, I'm happier than a puppy with two peckers over how this Garmin unit fits above the mirror.
Needs a power cable extension and some tucking of the wires. Other than that, the little bit I've played with it, it's awesome.